Note the yellow circle, bullet connects 2 gray wires?
Customer got terminator from the A, no color markings, just noticed pin locations are different, I will find a mercury one for it.
546395
Type: Posts; User: lpugh
Note the yellow circle, bullet connects 2 gray wires?
Customer got terminator from the A, no color markings, just noticed pin locations are different, I will find a mercury one for it.
546395
No cable to front of boat, terminator lower left, vvm lower right in first picture.
Notice the second pic. gray wire and brown/white spiral stripe wire connected to the diag port? Not connected to...
Sure will
Is the seal in place and good that goes on top of the high-pressure pump that seals it to the vst top for the fuel outlet?
Connected to the diagnostic connector, the other ends no connected!
This is the same motor in the post about no RPM reading on the vessel view mobile.
1B071442 . Vessel view mobile (not link)
All other data is availble, Diacom shows no faults and RPM, bad unit maybe?
Factoy analog tach is erratic and very false RPM with motor running, using the...
2004 Cougar, I see no access to remove the shift assy. Looks like I need to cut a larger access hole where the LiveWell control panel is, my 02 cougar is all open in that area.
the flat has rolled over, ball side is up
Duplex is just 2 wires not twisted in most cases in a sheath
I make the stainless straps and post adaptors myself from stainless straps, I have a milling machine, can also be made with a good drill...
^^^^^^ +1 this is how I do them, stainless strap double duty wrks as a mount an connector
545956
1. test battery SOC and condition
2. voltage drop from battery positive to power point on motor
3. drop test form battery to a good to motor block and starter case
Battery post not the connector...
Here is a guide line for you, note the twisted pairs, very important for clean power.
No duplex wiring please unless it is prefabbed twisted, 3 to 5 twists per foot.
545929
^^^^^^^ Plus 1
The Fury 4 will soon become a badly out of balance Fury 3:laugh:
I am not guessing, battery bad or insufficient for the job or both.
fill all the way to top, trim motor to get last little bit of air out.
2 screws hold a stainless clamp Brackett in place that retains both lines ( 5/32 hex Allen head)
Then line are pushed into the rails, the O-rings seal that connection, they will be stuck in there,...
Looks to me like 2 problems, Down scan overlay set way to high and surface cluter setting to low
How do you know it was an low alarm?
Thermoset stuck open, idle for 5 minutes without reaching 120 degrees will set a code and a 4 beep alarm.
Scan computer fault history will confirm if this was the case.
Got to those temps, cold...
Not for a bass boat, that is bare minimum, no electronics, LiveWell's ets. REcomend 950 CCA and 185 minutes reserve capicity at least. Some guys with larger and more graphs need even more
When does not start is what is important to us.
compression test first thing, got to make sure the motor is sound before making other repairs.
When it does not start do you hear single beep at key on?
I would start by checking the master power relay for proper operation when in failure mode.
Cannon plug
key switch
neutral safety switch
solenoid
electrical connections