I would try a tempest plus in 27 pitch. It will get better bow lift than the t1 unless it has been modified. Would also try raising to 2.5 ptp and watch your water pressure. Depends on which 200 you...
Type: Posts; User: 501nmc
I would try a tempest plus in 27 pitch. It will get better bow lift than the t1 unless it has been modified. Would also try raising to 2.5 ptp and watch your water pressure. Depends on which 200 you...
Most of the reed modifications done now are just replacing reed valves after lapping the cages. The cage openings can be enlarged some but you have to know what you are doing and have the right...
Hello everyone,
Has anyone mounded a fire extinguisher in their boat? I would like to mount mine under the driver seat either in the fiberglass or on the floor (probably on the floor). I was...
How are you getting your rpms? Really sounds like your tach is off unless the motor has been flashed and the rev limiter raised. There are several posts about different props. A lot of them say the...
Had twin 16 gallon tanks on my 190 with a 175 hpdi. Could go about 40 miles on one tank a lot of that was wot. You should be fine with the sho unless you're making extremely long runs to fish.
Well... I think my problem is fixed. Seems to be the prop. Bought a 22 t2 to try and the difference is night and day. Not as fast mind you but the handling is greatly improved. Guess I'll send the 23...
More than likely, you'll want to put your prop shaft at 4 1/2 prop to pad and a 21 pitch laser 2 prop. That's about all she'll do. The 24 pitch is just too much for a 115. My high output yamaha v4...
Thanks for the replies. I'm not necessarily a speed demon. There is a big difference between 63 in my old boat and almost 70 in this one. I bought another prop that should be here this week and plan...
Hello everyone,
I've been driving boats since I was 10 but that doesnt mean I know how to drive them.
Currently own a 21 zx200. Here's the question. I can trim 9/10ths trim and wot and...
If you look at your nmea device list, do you see the engine?
Thanks for the replies. I bought the 2 in 1 and the skimmer with the y cable. Got it installed, skimmer in the bilge and 2 in 1 on the jp. I have a lot of interference in the 2 in 1 on sidescan with...
Thanks for the replies. Boat has 3 hrs on it. No stumps. Lol. Prop may be out of balance, didnt think of that. Vibration seems to diminish some the more I drive it , may be that I'm getting used to...
Hello everyone,
Just wondering if anyone else has a cavitation issue with their sho.
Mine starts around 2000 rpms and is there til about 4000 rpms. Goes away once you go above or below those...
Thanks for the replies. I was referring more to the 3 in 1 transducer. Hds live has 2 transducer ports where elite fs only has 1. 3 in 1 duce wont work at speed being so big. I just wondered if they...
So... I finally found the xducers and y cable. It seems that maybe lowrance is discontinuing or are completely out of these items. My next question is how are you getting 2d or bottom contact at...
Hello everyone,
I would like info for transducers for these units. I would like the 2 in 1 active imaging transducer and the 2d transducer with temp. Do you have to have the splitter cable to...
A bailey's fin will help low speed porpoising. A tempest plus prop with extra cup will help also.
I'm sorry. I read that wrong. I thought you were connecting via a nmea network not ethernet.
Hooked mine up to lowrance ti1. Nmea starter kit, short nmea cable @8 ft, hummingbird will probably need the adapter shown above. Snip off the white connector on your motor and match the wires from...
Did my o2 sensor service after 280 hours and it was the same as yours. Lower compression.... is it on the bottom left cylinder as you're looking at the motor from the back? Mine is lower in that...
Sweet! Congrats on the new boat!
I run 63 in the winter with a 175 hpdi on a zx 190. Skeeters aren't the fastest but have a stable ride for sure. I have a 23 vmax sho t1 prop if you would be interested. Its 14 1/2 by 23 vented sho....
Rick, how do you like your 250 compared to you 190? I like my boat but would like a little more storage room. I love the ride of mine when it's set up for it.
I crunch some numbers on that calc...
The original xducer was in the bilge (hummingbird) the unit was an older one and wouldnt keep depth at speed. I split the lowrance xducer with the long 2 in 1 mounted on the jackplate and the 2d...
From what I've read... it does. I cant remember off the top of my head what it does to the motor. Most that I have read about run a 22 pitch non vented prop for best holeshot and turn 6k rpms.