Anybody use these guys for motor work? I`m looking and was considering trying them.
Type: Posts; User: bass-action
Anybody use these guys for motor work? I`m looking and was considering trying them.
I can tell you first hand that bulk mulch is far superior than bagged.
I think tank 2 does not recognize fuel, pretty sure it's water or oil. I would post this in the mercury fourstroke forum, you'll get an answer there.
https://www.bbcboards.net/forumdisplay.php?f=203
No,not serious.
These bigger motors will ruin fishing!
My next will be a proguide.
You don't want to be attaching it to the buss bar in picture. I would tape it off and leave it alone,for time being. Take the time and turn everything on one at a time to see if you have something...
Emailed Odyssey about this,this was the response,
10 amps is the minimum required charge current for our ODX-AGM31M battery. As long as the charger has an AGM setting it should be fine. Our...
Same here. Mid torque is what I have more that you need.
For what reason? How do you know only 80%
It does. Just curious why Odyssey does not have it on their recommended charger list.
OK thanks, I have a Noco Genius Genpro 10x1 in my posession,will this adequately charge Odyssey 31M-PC2150 ?
Will a Noco Genius genpro 10x1 properly charge an Odyssey 31M-PC2150? Found some literature on the Odyssey recommended chargers,noco was not listed,but the literature seemed dated
Ran spread sheet. If I run just graphs, I should be good for close to 10 hours.
Thanks Paul, I think that's what I'm going to do!!
New 31 Odyssey, replacing Relion HP100. Have life left in the Relion and was thinking of putting it to use,maybe it would prolong the life of AGM. Honestly was just considering not parallel and run...
Installing an Odyssey AGM for cranking and thinking about running a Relion HP100 in parallel with it.
This is what I'm thinking about set up. Running parallel. Hook up all accessories( graphs,...
Got the plug through to the motor and plugged in, fuel gauge is good to go now!! I need to find a new dealer! I shouldn't of had these issues.
Thank you Don,I can't tell you how much you helped me...
Did some scrounging, I guess it is mega long! I think there is enough room to fish that plug through the tube. If not would depinning it be an option? If so do you know the procedure of the...
So after looking I'm guessing the fuel paddle oil harness I is the 6 pin boat harness? Is this what needs to be hooked up to the new motor for the factory fuel gauge to work? Is this also called the...
Using the original 2 stroke harness, only thing I have coming off that is the fuel paddle harness and the e oil tank sensor. Does that fuel paddle harness hook to the 6 pin boat harness? Is there an...
Serial number 3B267108
Previously 2016 ProXs 250 2 stroke with mercmonitor. Repowered to a 2023 4 stroke with same Mercmonitor and reused existing 2 stroke harness, Mercmonitor was reset....
Don`t really like that slot. I would do a complete ring of silicone around each bolt hole the shape of the slot, then very liberal on the bolt washers on the inside of transom. Then completely fill...
I've stayed at Rip Van Winkle couple times, it was decent, get a cabin if you do. Nothing special. Definitely not the Super 8 worst place I've stayed anywhere.
Serial # 3b267108 .I want to go off the terminal post on the Odyssey battery and do not want to cut factory terminal ends off. Are these acceptable ways of doing this?
541631