Search:

Type: Posts; User: JOE54

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. #18 on fuel management system breakdown 827694...

    #18 on fuel management system breakdown 827694 new number is 827694A01 comes in a set both hoses molded , brace yoself
  2. Replies
    14
    Views
    263

    see any fuel leaking from bowl vent ????? also...

    see any fuel leaking from bowl vent ????? also that mtr has bleed system restrictor's behind reed plates that may be giving you a problem letting fuel build up in reed area when idling will act as if...
  3. Thread: 2007 optimax

    by JOE54
    Replies
    12
    Views
    165

    many hrs on that mtr ?????

    many hrs on that mtr ?????
  4. Thread: 2013 optimax.

    by JOE54
    Replies
    8
    Views
    246

    now then , propshaft failure in 2012 , replaced /...

    now then , propshaft failure in 2012 , replaced / oil pump in 2014 also replaced , thats it good luck with it
  5. Thread: 2007 optimax

    by JOE54
    Replies
    12
    Views
    165

    more likely load on compressor relieved ,...

    more likely load on compressor relieved , anythings possible , bearing spin smooth and quiet ?????
  6. Thread: More oil issues.

    by JOE54
    Replies
    18
    Views
    477

    as have i same results ^^^^^^^

    as have i same results ^^^^^^^
  7. Replies
    24
    Views
    435

    good luck WILL :thumb up2:

    good luck WILL :thumb up2:
  8. Thread: 2013 optimax.

    by JOE54
    Replies
    8
    Views
    246

    yep ^^^^^

    yep ^^^^^
  9. Replies
    7
    Views
    186

    ^^^^^^^^^+2 shake t up good and run it

    ^^^^^^^^^+2 shake t up good and run it
  10. Replies
    7
    Views
    159

    ^^^^^^^+ 1

    ^^^^^^^+ 1
  11. Thread: Water separator

    by JOE54
    Replies
    4
    Views
    177

    :thumb up2:

    :thumb up2:
  12. Replies
    37
    Views
    1,061

    does not appear to be quicksilver fuel line to me

    does not appear to be quicksilver fuel line to me
  13. Thread: Motor Trouble

    by JOE54
    Replies
    12
    Views
    296

    ^^^^^^^++++++:thumb up2:#5 and #11

    ^^^^^^^++++++:thumb up2:#5 and #11
  14. Thread: 2007 optimax

    by JOE54
    Replies
    12
    Views
    165

    test engine as suggested above ,hard to tell , do...

    test engine as suggested above ,hard to tell , do not run it any more until noise is found
  15. Replies
    1
    Views
    61

    well we know its had cowl change because they...

    well we know its had cowl change because they didnt make a oil inj engine in 1980 , MERC says ser number not found , see if title number matches ser number on plug on top of block , what hp does...
  16. :thumb up2:

    :thumb up2:
  17. Replies
    3
    Views
    97

    these engine can and will exhibit this condition...

    these engine can and will exhibit this condition at certain rpm when the reeds are trying to go from normally closed to mostly open , nature of the beast , i would still check for fuel in air side of...
  18. Thread: Bad TPS?

    by JOE54
    Replies
    5
    Views
    128

    w/p is too low while replacing w/p tuner can be...

    w/p is too low while replacing w/p tuner can be observed through exhaust housing opening ,take long screw driver and see if its loose or fell off , also check for more fuel in air side of system
  19. Replies
    9
    Views
    272

    replacing top cowl can cause wires to be...

    replacing top cowl can cause wires to be disconnected sometimes , tie strap to high press fuel line cures it
  20. Thread: More oil issues.

    by JOE54
    Replies
    18
    Views
    477

    any TCW-3 will work ,and it will didnt say it...

    any TCW-3 will work ,and it will didnt say it was the best or whats recommended
  21. 8m0042285 MERC DEALERS need 2 of them

    8m0042285 MERC DEALERS need 2 of them
  22. Replies
    2
    Views
    72

    uh uh uh diagnostic port :doh:i think , please...

    uh uh uh diagnostic port :doh:i think , please use v6forum one more down list for yo engine , with ser number
  23. float levels ,carbs flooding , bleed restrictors...

    float levels ,carbs flooding , bleed restrictors ,pump diaphragm for starters
  24. Replies
    24
    Views
    435

    sure sounds fuel psi related to me MUSK

    sure sounds fuel psi related to me MUSK
  25. Replies
    12
    Views
    218

    sure is GEN 1 torque master direct replacement...

    sure is GEN 1 torque master direct replacement for yours, major shimming required to install that shaft in your gearcase extensive knowledge and special tools required for that install :wink:
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4