I would think no matter what you are running you could contact the Parts Dept. at Ranger and they should be able to help you get the material as they do stock it for their boats in production. There...
Type: Posts; User: Randy Carter
I would think no matter what you are running you could contact the Parts Dept. at Ranger and they should be able to help you get the material as they do stock it for their boats in production. There...
All boats are going to backwash to a degree. If nothing else water will gather in the splashwell which is technically considered backwashing. Now of course there are those out there that will dump...
You might take a look at the water tube fitting on the lower unit to be sure it is not cracked and losing water pressure when up and running when more pressure is on it than there is at idle. Also as...
Will definitely have to be modified , a lot of guys are struggling with same issue. No other way to resolve.
It is just about time for our 2019 Open House here at Anglers Choice. We are very excited about the show this year and want to extend an invitation to all who might want to attend. There will be a...
It is just about time for our 2019 Open House here at Anglers Choice. We are very excited about the show this year and want to extend an invitation to all who might want to attend. There will be a...
This is just a thought but you might check the lock rails. Unless the bow is raised a good bit at the tongue the water will stand in between the box lids under the rails and could run in through the...
agreed
As stated previously the assembly on the right is the latch for the T-lid. The slotted screw holes attach the boat , the flat part sticking into that goes on the lid, not completely to the top but...
Smalliefan is exactly right. If both your pumps are not running the livewell will not fill to capacity. As stated check fuses and remove the pump that is not working from the pump housing to be sure...
It is just about time for our 2019 Open House here at Anglers Choice. We are very excited about the show this year and want to extend an invitation to all who might want to attend. There will be a...
It is just about time for our 2019 Open House here at Anglers Choice. We are very excited about the show this year and want to extend an invitation to all who might want to attend. There will be a...
Is the console unit doing the same thing , normally voltage drop will take both units down. If not , as stated earlier check power and ground connections to the unit on the bow to be sure they are...
If you have a bounce buster attached to the trolling motor it may be set a little high not letting it lock in place. If not , make sure that the bracket is not of the Ultrex is not contacting the...
As stated in previous posts, You might want to replace the power switch on the foot pedal. We have seen several of these go bad and cause weird issues.
I think a lot of folks overkill when it comes to the trolling motor. When talking about a 19' boat , 80lbs. is more than enough power in most situations. Unless you are fishing up north a lot on big...
If you are replacing just the wheel and order this from Ranger to fit then you should just be able to remove the screws and replace with the new wheel. If you are replacing the entire assembly then...
The steering system will not bleed itself when fluid is added. You will have to bleed the system manually. There is a hose kit available to do this which is basically two clear hoses, one with a...
This can depend on the time of year you purchase and the schedule of the dealer in question. Normally you would look at 4 - 6 days in Spring. This time of the year though you could probably cut that...
I can understand your hesitation on this. Not sure why this dealer would require this of you. Here at Anglers Choice I have taken many customers out for lake testing and have turned the boat over to...