Don, thanks for your response ... hope you can help me make some additional troubleshooting moves here.
Made an error in post #1
"Trim only in one direction (up) at both engine & helm switch"...
Type: Posts; User: RollinEEZZ
Don, thanks for your response ... hope you can help me make some additional troubleshooting moves here.
Made an error in post #1
"Trim only in one direction (up) at both engine & helm switch"...
SERIAL # 2B251790
MERCURY 115 HP OUTBOARD
Trim only in one direction (up) at both engine & helm switch
swapped relays, still trim in only one direction (up)
crossed blue & green wires;...
Roger that, thanks for sharing knowledge
YAMAHA T50TLRA
64J L 409882
would like to bypass PT&T solenoid for troubleshooting ... Is it acceptable to connect 12v to the green & blue terminal posts w/o disconnecting the wiring from the...
... did a little more research ... looks like they are for the bleed system?
Bleed system recirculates puddled/unburnt fuel, moving it to another area of the engine, where it can be used for...
Serial # 1B514135
hose behind the starter & electrical components has a split in it & spraying out fuel when engine runs.
Looks easy enough to fix (my plan is to remove starter, if that's not...
Have a circa 2002 Merc 40 HP 2 Stroke (sorry, serial number has been peeled off and cannot provide) and ignition switch needs replaced.
I believe it needs a Magneto type ignition switch but also...
The Fuel Demand Valve was the culprit.
Replaced the fuel filter & fuel filter o-rings ... problem persisted.
Noticed the fuel demand valve (FDV) was leaking fuel out of the 4 small pin holes...
... will do, thanks for response.
SERIAL # 2B251790
Are external (boat side) fuel filters acceptable for use w/ this engine?
I installed a Racor 120R-RAC-02 Fuel Filter in the watercraft. It is located after the fuel tank...
Mercury 115 HP 2B145753
Boat had a dead battery, installed fully charged battery. Soon as fresh battery was hooked up starter solenoid started engaging / disengaging (click, click, click). ...
does anyone know where to purchase or have a part # for the fuel connector pictured below? I've seen them on recent model Mercury 4 Stroke Engines including 90 HP & 150 HP models
...
Thanks for all the input ...
The manufacturer of the boat I'm working on, brunswick corp (bayliner, boston whaler, sea ray, lund, lowe, etc), rigged the boat w/ sealant on the barbed fittings so...
Just curious what's your reason for recommending against the use of http://www.bbcboards.net/attachment.php?attachmentid=273806&stc=1 worm clamps? Is it because you're concerned about the metal edge...
Greetings
Will be installing water separating fuel filters on our rental boats (all have mercs). Been doing research on fuel line sealant (teflon tape is a big no-no here in case anybody is...