Search:

[QUOTE=Wayne P.;13142478]There have been two basemap updates since 2.110. You have to have the second one to use the current Lakemaster VX map cards.[/QUOTE
Thanks wayne

I fish a 1000 acre lake 99 percent of the time. Don’t use 360 or ML. They are both Helix 10’s MSI G3N bought in 2019. When I bought them I did the 2.110 update. They have worked flawlessly. I know...

To enter a coordinate like this N 00* 00 00.00 W 00* 00 00.00 would dd* MM.MMM be the correct format? will just be changing the console unit. Would i have to change the format on bow helix also to...

To enter a coordinate like this N 00* 00 00.00 W 00* 00 00.00 would dd* MM.MMM be the correct format? will just be changing the console unit. Would i have to change the format on bow helix also to...

Problem solved with loosing network tab on console Helix. Reversed they the way i usually start them up.(don't know if that made the difference) This time bow first, then console unit. Checked and...

Thanks Wayne but I don’t have the network tab even after restoring factory defaults. Made sure I had set to custom. Just went and rechecked and still no network tab.

Do you know why my gen 3 helix 10 lost its network tab and also it will not change to heads up. I installed a AS GRP puck and even used the network tab to select it.

Thanks.

Got the heading sensor mounted and everything works fine. Course and direction line right on the money. Going to mount a AS GRP on the back of boat for the console unit. Anything to look out for...

Thanks for the input.

Going to ask what is probably a dumb question but here goes. Mounted the sensor up front. From what I seen it says the heading and course lines should be within a few degrees of each other. I’m...

[QUOTE=CatFan;12753040]Step one is to run the motor on 100% and see if the interference goes away. If so, it’s electrical noise being coupled from the PWM pulses into the electronics.

Do you have...

Will do. Its frustrating. Probably be spring before I try to figure out what's going on.

Thanks for the replies.

When I got my new boat last year I installed my Helix 10 MSI + G3N on the bow. Power wires and transducer cable are separated. I have the new Motorguide Tour trolling motor. I could run it at any...

Thanks Wayne

Here's my set up. I have a Tracker 190 with a dedicated battery mounted in the center storage compartment to run both Helix units. 3 foot run to console with 12 gauge wire and about 8 feet or so to...

Thanks Wayne.

Would a Helix 9 service for a mapping unit only? Would be used at the bow.
Thanks

I’m embarrassed to say that I reversed the wires on the battery. Everything working now.

I have always just disconnected the powers wires to my Helix's and charged the battery. After battery charged hook wires back up. Never a problem. This time same way now neither helix will power on....

Try the Cabelas in Lexington, ky. Says limited stock but i put one in cart went to checkout and it didn't say none in stock.

Thanks guys.

Is Windex with vinegar safe to clean the glass?
Thanks

Thanks for the input.

Thanks, they will avoid the trolling motor wires.