I found one on ebay and it cured the problem, thanks to everyone that helped
Type: Posts; User: edwardsmo
I found one on ebay and it cured the problem, thanks to everyone that helped
I guess i need a pdp i changed lower unit lube went to trim it up would not work again. It worked up and down with all the switches it sit few hours than it would not work again.
Thanks Bassmeister it worked, been messing with it for a week.
I will try it thanks.
Are they repairable?
yes it same up to the 250
Could it be something wrong in the power distribution panel ? It shows power come out of it on the down side but no enough power to run the trim motor.
I have checked the trim motor ground it looks like it should. i can get power to the green wire where plugs in on the motor from every switch but not the blue wire but i get power to the blue wire...
Thank you i will check thr ground out did not know where it was grounded.
I have replaced the relays, it didn't help.
I have a 2001 Evinrude E175FSLSI I have jumped from battery and can get it to go up and down. With a test lite i have power on all switches even where the power comes out where you plug in the motor...
I can make the trim motor raise and lower with a jumper wire, but with none of the switches, i put new relays in, i can heat them click when i try to trim it up with the switch. I don't know what to...
I only get power to the 2 wires that come out buy the distribution box when i push on trim button to go down shows no power when you push to go up. Is there a test to see if trim motor is bad?
I have been unable to work on for a while. Today i hooked a test light to the motor ground and checked to see if any power coming out of the power distribution box there is a green and a red wire...
No sound at all How many relays are there for the trim?
2001 Evinrude 175 E175FSLSI none of my trim switches work is there a fuse or something that controls power to trim motor? i hope it is not the trim motor, it worked fine and then it didn't.
I have no power to the switch. the check engine lights do not come on when i turn on the key i replaced the solenoid, i cannot find a bad fuse, i am pretty much out of ideas.
2001 Evinrude e175fslsi try and start will not turn starter you can jump the solenoid the starter will kick in but not with the key. First time starting this year it started fine when i put it up for...
It starts and idles it just dies when advance the throttle.
No it does not make any difference.
I checked all the fuses in the PDP and all good no wing nuts on battery.
I have a 2001 Evinrude 175 E175FSLSI Last time i ran my boat it ran fine, it has set on my lift for 2 weeks ,went to start today would idle but kept dying. Then i could tell when i turned my key on...
My motor is a 2001 175 evinrude E175FSLDI Why or how do you sync your CPS? Thanks for any help.
Thank you does the motor have to be running for EVdiags to do that?
I have a 2001 175 evinrude E175FSLSI that dies when try and take off could it be throttle sensor? When you apply the throttle when the throttle sensor reaches full advance and the throttle starts to...