Search:

I need to replace the fenders on my 1987 skeeter boat trailer, does anyone know where I might find them? thanks for any reply.

38

I fished rocky today on the east end , water was open as far west as I could see saw a few boats out too

I found the two carbs were loose I tightened them up and tried the piece of paper on each carb and it sucked in on all three carbs . I will try it out on the lake and let you know if that helped ....

70 hp Johnson j70elcur it has gas spitting out of the front of the carburetor when it is running the top and middle carbs not the bottom carb I checked the float level in all three carbs they...

I just checked the site out the lakes with a * beside the name of the lakes are the ones that allow idle with big motor. cowan isn't one of them, but should be

thanks for the two replies. I am going to premix

1989 175 hp Johnson j175stlcer low oil pressure beeper comes on after a minute . the oil bulb is hard as a rock, but I can pump the bulb and the beeper quits for awhile then starts again until I pump...

who is running the Monday night tournaments now

yes , in the settings there are around six different transducers to choose from I found mine was on the wrong transducer when I had it on down vu it shows the transducer number on the bottom left of...

I had the same problem with my 7sv it had thr wrong transducer number in the setting I can't remember what number it was showing but it wasn't the right one, put in my transducer number cv52hw and...

anyone know what the winning weight was in the rocky fork tournament today

thanks for the replies . i'm going to have them changed . better safe than sorry

two of the carbs have a very small leak from the bowl . I took the carb off and while they are off going to put new kits in, I was going to take the jets out to clean but the screwdiver slot is...

I went to the online omc/brp service manual site for a manual for my 1987 70 hp j70tlcur it only has a 1988 j70elcc manual . I want to check the timing on my motor ,was wandering if the 1988 is the...

thanks

I have a 1987 70 hp Johnson j70tlcur bought new champion ql77jc4 champion chart says gap .030 , the seloc manual says gap .040 do you think seloc is a misprint what gap should I go with

hydroplane races

todd, what was the winning weight friday

thanks for all the replies , it runs fine in all positions just a hugh difference in settings

edge 70lb 24 volt motor runs the same speed on number 1 and 2 on three it runs fast number 4 runs the same speed as number 3 setting, number 5 setting it runs extra fast . it has run like this since...

thanks, i'll check the scroll setting on sidevu and cv. I know when I go to cv it fills the screen from right to left in a second but sidevu takes for ever from top to bottm of screen

I called garmin they said that was normal for screen to load every time you switch from sonar or cv to sidevu. if anyone has a striker 7sv does it take 47 seconds to fill the screen everytime you...

I timed the screen when I switch to sidevu , it takes 47 seconds before it has a full screen

if I switch from sidevu to sonar or cv and switch back to sidevu it still starts to fill the screen from the top it never has a full screen when I switch to sidevu until it fills the screen from top...