If the vehicle is legally registered, sue the owner of the vehicle.
Type: Posts; User: wyngo
If the vehicle is legally registered, sue the owner of the vehicle.
The state has been taking my money and giving it to everyone else for free so why can't they cover the bill. Its a return in my investment.
Amen to the fluke. Love that bait for smallies.
the last of the dogmen, the 13th warrier, Instinct with Anthony Hopkins.
Trailer to Vermont and fish the Gut, Carrie Bay, and Keller Bay is not too far either.
Stay away from the Days Inn
Make sure the red lever on the choke is in the right position
Use two inches of the fiberglass board cut 1/4" short all around then fill the gap with spray foam as this will stop the infiltration. Fill the remaining space with fiberglass, blown in, etc.
Started working on a 1994 40elpto to replace the seals in the bearing carrier. Well upon removing the seals we found where the water is coming in as the carrier is cracked. Any ideas on where to get...
check to see if the chimney is plugged, and low temp flue gas will cause moisture, quite a bit a times.
If the prop has vent holes, put plugs in them
Yes, the bolts are completely out. Was hoping not to put heat to it, but will do what needs to be done. Thanks for the help.
I have a 1989 Johnson J150STLCEM that the lower unit had quite a bit of water in it before it was winterized. Figured I would replace the seals until i went to pull the housing seal assembly. I guess...
heck your wiring, Had the same issue one time and the molex plugs were not fully seated to complete the connection.
If your staying at the Anchorage, just talk with the owner Dave. He is a very good fisherman and can help you out.
largemouth - mister twister top prop
smallmouth - jerkbait
sent a response, not sure if it went through
Yes.
Depending where your fishing it should be a little of both.
If work was done to it recently make sure the wire connectors are fully seated.
There are nuts on the other side that came loose
I ended up peeling back the wrapping on the wiring harness and found these to be grey wires that connect to the tach. Also found out the tan sensor wires are green under the wrapping and after...
The cover to the terminal strip has been missing for as long as I remember, and I believe my photos were on another computer that crashed a few years ago. The manual I bought is for a 1990 as I...
it has a round spade connector as if it is to be connected to the terminal block, that has the yellow, yellow/grey,grey,red, and purple.I believe it is for the sensors, but not sure they are powered...
http://www.bbcboards.net/attachment.php?attachmentid=336003&stc=1 Here is the ones in question.