Search:

Any feedback on the Dobyns baitcasting reels?

I was walking up to my trailer and noticed I lost the lower nut and bushing on one of the shocks. The shock was out of the lower mount and only hanging on by the upper mount. Was a pain to replace...

Did you have to remove the leaf springs when replacing your shock or did jacking up the trailer give you enough space to fit the shock in the mounts?

I spliced into either the ignition wire or off the smart craft, can’t remember. I think it was the purple wire.

On my helix 10 g2n I have shut it down while in “sonar off” then powered it up again, then turn “sonar on”, I cannot see 2D or down imaging. I have to restart it with “sonar on” to see sonar. It did...

I updated one of my helix 10 MSI g2n and everything is working fine including the standby mode now

That’s a good point, a good argument for a replacement transducer. I rolled the dice and updated my front graph today and standby mode now works like it should.

Just got an email from Humminbird saying it is a glitch from the last update and is going to be fixed with the next one.

I’m guessing it has something to do with the newest update

Downloaded the update to a card and units have the current software but no change to the standby mode. I e-mailed Humminbird about the issue and their response was a link to an article talking about...

Reset the front graph to factory defaults and still pings in stand by. Rear graph also pings in standby. I won’t have a chance to mess with anything else till after the weekend. I will update with...

Only reset before, will try that as well

Yes then updated through the app. Only noticed it with the front unit with an ultrex and built in mdi transducer. Not sure if it’s doing it with the rear unit that is the same unit and I updated at...

Just did the latest updates with my Mega g2n Helix 10s and now the transducers still ping when in standby mode, anyone else deal with this?

Well not sure if what I had was packing grease but what I did have was water intrusion. Everything getting replaced by MinnKota :thumb up2:

Push the light/button on the heading sensor then push and hold the pairing button on the ultrex head and you will hear it beep a couple times when it’s paired

It’s gotta be paired with the heading sensor for the calibration to show up on the remote.

Thanks

First time out with the new Ultrex. Pulled it out of the water for the first time and ran across the lake. The water from the trolling motor dried leaving behind a greenish residue but it cleaned up...

Same issues here, 2017 721