920 elite total of two batteries 1 lithium for starting and electronics 25 lbs 1 single 36 volt battery for trolling motor lithium pro 29 lbs . I do not see any disadvantage in performance I run a 25...
Type: Posts; User: skpeter
920 elite total of two batteries 1 lithium for starting and electronics 25 lbs 1 single 36 volt battery for trolling motor lithium pro 29 lbs . I do not see any disadvantage in performance I run a 25...
Measured mine just now it's 20ft back side of tire to front of tongue plus or minus an inch I have a 920 elite with the warrior wheels
Actually my mistake I believe I saw all the deck dimensions on the latest brochure which is in the sticky section
I do believe the elite is just as fast never ran an xp but my elite runs 76 loaded up 78 solo loaded
Check out the latest dimensions on the phoenix site . I have the 920 elite when I saw it it was a no brainier for me but that's personal preference . Lower gunnels wider front deck slam latches the...
I'm not sure of measurements but I have the rampage wheels to me it really doesn't appear to be higher than standard I believe the tires are actually lower profile just my opinion
I have it in my 920 elite and I does show dirt very easy but it's seems to also clean off fairly easy I have never had an issue with stains . There isn't much gel left to scratch up at least I have...
920 elite 25 fury 3 blade 12 ok inch atlas lithiums 5950 running 78 livewells empty 76 wells full not sure why but I did pick up a few hundred rpm after I got some hrs on the motor
The wider deck and the lower gunnels made the 920 elite a simple choice for me but that's just personal preference
Not worth it for the motor alone imo went from 2 stroke to 4 stroke not a huge difference
Fished the entire season in mine it's a great boat the deck is wide gunnels lower than the other models floats shallow and flys . It's great with the trolling motor down . Rides nice and drives easy...
Thanks for your answer I will follow your advise
250 pro xs 4 stroke sn 2b745842 question does anyone have knowledge on stainless steel skeg protectors as far as recommendations on brand and if it causes any loss of performance in speed or...
That's what I was going to do only problem is now I can't even get it to act up .out on the water I unplugged the bow switch and the console switch and it still had the issue. The only switch left is...
Thanks for all the help . Sorry about the wrong forum didn't look closely enough just saw pro xs
I have 2020 250 proxs 2b745842 I have a clicking noise like a switch is clicking on and off this is also with the key off only way it stops is to pull the Merc clean power fuse . A couple times...
Any luck with the 25 tempest
Stealth charging look it up on line it's a great system he has ac and dc
Did you find a fix for this mine does the exact same thing some how it must be twisted but I haven't hit anything solid it's been like this from day one . I notice with the motor up the inside of the...
anyone else get a special boat with the screws being to long on the battery compartment lid chipping the finished fiberglass or just me. these are the screws that mount the buttons for your cover on...
thanks coach sounds like we are running pretty close to the same except i cant get that kind of speed with the 24 im running a 25 less rpm but 76 to 77
tighten up all your hinge screws and all your screws on your latches they will fall out 1 by 1
i re did mine i used a stainless steel hose clamp mounted tight to the fiberglass and drilled a hole in the band after clamping it to the unit then screwed to the fiberglass now it will not bounce...
And the way the round water pressure sending unit is mounted under the console is horrible hanging by 2 tie straps
Water tube came off water pressure gauge under console easy fix but you have to take the console top off had same problem on a 920 elite