I had a conversation with a friend of mine this morning about this and he told me the exact same thing.
Type: Posts; User: rammerjammer
I had a conversation with a friend of mine this morning about this and he told me the exact same thing.
I did a search and checked the installation manual and can't seem to find the answer to my question but there are two O- rings shown as parts needed for a hub installation:
...
Is it safe to say the o-ring Marine Master sent with the race, x2 bearings, and cap is for the ring that seals the cap to the hub?
When I took my hub off the spindle, the race was a pain to get...
Yes, I'm looking at mine now.
Thanks again guys. This has helped get my mind wrapped around how this works.
No brakes. And I believe the nut is 18 to 20 in/lbs or hand tight based on the literature i just read.
But thank you, that assured me how it works!
Alright folks dummy this down for me. I just found that I've got a rear seal leaking, oil all over the inside of the front starboard wheel. I am going to attempt to make this repair and have looked...
Width and I believe the standard graphs are bigger on the 920.
I don't think the 920 is faster than a 721 though.
I'm not replying to start the same argument over an over again but, I've got a 2014 721 w/ 250 ProXS and dont have to drive it unless I get up around 78 mph. I came out of a skeeter and there is zero...
Yes, plugs were replaced AND gap was checked.
Yes, plugs were replaced AND gap was checked.
It is the most noticeable after priming fuel bulb and morning warm up during the initial run down the lake at WOT (5750 - 5850 rpm). The miss or hesitation is usually gone after this first run for...
Absolutely not and no disrespect taken. And yes, your statement about present and FUTURE is precisely why I started this thread.
Thanks for the info Eddie. I am hoping that I'm just going through the gauntlet and she will get squared away soon.
This item was recommended by the service technician although not mandatory based on inspection. And it is Platinum Coverage and not a Warranty.
I agree with this statement but based on your experience, IF the "new operator" starts performing proper maintenance - do the bugs get worked out (much like often times with used automobiles)?
Specifics: 2014 Mercury 250 Pro XS, S/N 2B021994, 25p Fury, 391 hours, installed on 2014 Phoenix 721 Pro XP, hydraulic jack plate.
First and foremost, I DO NOT want this to turn into a rant or...
No worries chavis. I just wanted to make sure!
Thanks Savage. I kept on digging and found the thread where in big red letters it stated DO NOT DRAIN on wingmasters.
Thanks.
Do you drain from a torquemaster 2 as well?
2014 250 ProXS with torquemaster 2. Serial 2B021994
I've read multiple times here to drain an ounce or two of lower unit oil out of the LU once full to prevent damage to the seals once the oil...
You are welcome friend. Ended up catching just shy of 11 pounds and we finished 9th overall in the Ironman.
Yes sir. I'll be in Charleston this weekend but I'd be happy to take you for a run any other weekend.
I have ran 90 octane ethanol free and noticed that the inside of the prop hub gets alot of carbon build up even when running Don's cocktail. If I drop down to 87 octane, the hub seems to stay...