Thankyou Bowhunter, I was only in need of it at the transom.
Cheers.
Type: Posts; User: bercy38
Thankyou Bowhunter, I was only in need of it at the transom.
Cheers.
420388
Hello,
Would anyone know the deadrise of a 2000 194 Fish hunter?
Thanks,Marcel
Thanks Don!
Sorry about that.My serial number is 0t019539. I do not have the other.
I have a 2000 200 optimax that needs a low pressure fuel pump(electric). Would a pump for a 2000 200xs opti be the same pump?
What is the low pressure electric pumps purpose and what are the symptom's of it failing? I will check high pressures tonight.
I haven't checked any of the high side pressures,tough to do when on the lake.
Having a problem with what seems like fuel supply. Pump the ball till hard and start engine gets on plane and runs fine. 30 sec later it starts cutting out,if I back off throttle it may stay running...
So is the direction I should head in a fuel feed blockage? Will I need any new gaskets or seals to remove and disassemble the diaphragm pump?
Message for Don or any other merc authorities. My 2000 opti 200hp OTO19539 ran fine half the day yesterday then would get up on plane then cut out for a second then catch for a second then cut out...
Sorry Don, for next time is my eng a 2.5L or 3.0L
Sorry Don,
I did all that years ago. The grey fuel lines were a problem but no problems since.
Message for Don or any other merc authorities. My 2000 opti 200hp OTO19539 ran fine half the day yesterday then would get up on plane then cut out for a second then catch for a second then cut out...
ok.thanks
When performing a compression test can the coil feed plugs be disconnected and does the kill switch shut down the injectors? 2001 opti 200
Hello, could anyone tell me the proper spark plug for my 2000 200hp opti serial #oto19539.
also wondered about proper procedure to do a compression test while plugs are out.
why y cable
Sorry Bob i am just switching between high speed shoot though transducer and slow speed si transducer. I had a switch but it is defective now so I was just wondering if i should replace it or go with...
I have a helix 10si. Should I use y cable or switch for the transducers and what are the benefits and drawbacks of each?
Signed.
Thanks guys.Merry Christmas.
Don do recommend replacing a slightly bent prop shaft or straightening.It is a 2000 200 opti.I figured. A serial number wouldn't be needed for this question.Thanks,
Thanks guys.