I am in the process of purchasing a Stratos with a 2008 Evinrude E-tec 200 HO. He is taking it in to get a compression check and to get a motor report pulled. What should i be looking for in the...
Type: Posts; User: jt1009
I am in the process of purchasing a Stratos with a 2008 Evinrude E-tec 200 HO. He is taking it in to get a compression check and to get a motor report pulled. What should i be looking for in the...
21XDC So i got out today and tried a tempest plus 23p i picked up. I am a little confused here. The set up was the same as running the Rapture 21p with the exception of ptp height. With the tempest i...
Well i picked up a Laser II 24p for a good price, and when i put it on i have a gap around the prop to gear case. So at some point the gear case has been switched out and is a large gear case. So for...
It is still in stock form, i was going off the manual that says operating range is 5000-5500wot. I have heard or read about the advance module but not entirely sure on steps to remove it. Also still...
21XDC even with too high of rpm that i am at now? I figured with high rpms's and moving jackplate up closer to 3.5 the 24p Trophy plus would be closer to recomended rpm range or am i missing...
I also came across a trophy plus 24p. Any ideas with this one?
I have found a 23p Tempest plus prop, now will this prop fit a small gearcase mercury?
So today i got out and did some more testing. With the ptp settings as i got it at 4.75 it ran 53mph at 5800rpm at half trim on the gauge. If my calculations are correct i could go to a 23p prop at...
Its ok, thanks for the recommendation.
Thanks guys, i have recently posted in the prop section as well.
I have a 1989 Stratos 285 pro with a mercury 150 xr4 6 inch detwiller jack plate. I currently have a 14.25x21 rapture originally set up with 4.75 ptp. I read industry standard starting point is 3.5...
For the ptp measurement i leveled the bottom of the boat at the rear and measured from the floor to bottom of boat, then leveled cavitation plate and measured from floor to center of the prop shaft...
I have a new to me 1989 285 pro with a mercury 150 xr4 with a 14.25x21 rapture stainless prop. Also has a 6" detwiller manual jackplate. I measured the ptp before making any changes and was at 4.75"....
Thank you sir, makes sense now.
I have a 1989 285 pro and was wondering about something. On the port side behind the rod locker there are 3 holes, 1 looks to be a cup holder and 2 other smaller but deeper holes. what are the 2...