How do you check the main relay? I was told you are supposed to be able to hear it click when the key is turned. I cannot hear anything coming from that area when the key is turned.
Type: Posts; User: Sfrye
How do you check the main relay? I was told you are supposed to be able to hear it click when the key is turned. I cannot hear anything coming from that area when the key is turned.
They are wet
This engine was blown. It has been rebuilt with all new bearings and pistons. It has new low pressure pumps. The injectors were sent off and cleaned and serviced.
When put back together it...
I am still trying to diagnose my engine as to why it wint start. I used a multimeter to ohm the stator and this is the reading I got. Is this bad or good. I am looking for answers before I buy...
It acts like it is getting too much fuel and flooding. When I took the air box off the front of the engine it had fuel running out the bottom of it.
Little update. The engine will start if you give it gas while you try to start it. It will not idle and if it shuts off you have to wait a few minutes before it will start again. Any ideas
The engine was just rebuilt. I got it to run now but it will not keep prime from the gas tank. All low pressure pumps were replaced. All filters were cleaned, brand new plugs. The 36lb of pressure...
It will turn over and crank for a second and then shut off. Then it will not crank again unless you let it sit for a few minutes. I have 36lb of fuel pressure from the high pressure pump. Any...
I have a 2000 ox66 and I need a few parts. I need s junction box cover, a flywheel cover and the cover that goes on the very front of the engine. If you have one or know of one let me know
Can someone tell me what the thread is on the crank? I need to buy a die to clean and repair a couple threads on the crank so I don’t have to force the flywheel but I’m and mess it up.
What does it cost to get a ECU flashed?
didnt want to overdue it.
I got them cut today. I got .040 cut off them. Is there a thicker head gasket I need to use and if so where would I get it
Thank you.
What does 91 octane have to do with it
I am putting my ox66 back together. I am wanting to get heads shaved. My question is how much to get them shaved and what can I expect performance wise with them shaved?
Still need a block guys. If you have any ideas where I can find one let me know
I am looking for a block for a 2000 ox66 200hp. Can have cylinder damage just no holes.
What you asking for them? Are they new or used?
Looking for a set of heads for my motor rebuild. Anyone have a set they would be willing to part with?