Search:

This morning I back off the screws a turn or two and will
See if the rubber relaxes a bit after the sun hits it.

I’ve had issues with the rubrail screws popping out or loosening up. How tight should the be after I put 4200 or similar sealant ? I tightened them down pretty good but that has caused waves in the...

So like the title says, I tightened all of the rub rail screws, and now the rub rail has waves in it. I’m assuming that the screws into the top cap should be run down tight What’s the trick to...

:salute:

That quite the achievement. Congratulations

Like the title states , I need the part number for rotors on a 2000 mfi trailer.

thanks.

Thanks guys. The agm battery takes a full charge but
maybe it ran low with the pumps and graphs running. I’ll check and change the plugs and take it back out

for Don. #1. What’s the average...

Back with another question before I put it in the shop. Will a cranking battery voltage in the 11v range cause a drop in engine performance and ability to get the rpm’s up? At the end of a...

Thanks don. I’ll add your site to my list of favorites. Another question but I’ll start a new thread

Thanks

For my 2000 TR20 I went with the Llbroc 204 seats. About 750 for seats, butt seat and folding back seat. They are a bit wider so I lost the middle seat. They are great

thanks for the link

Good morning Don and others.

for a 2016 PROXS, serial number 2B360237, would someone please confirm the Mercury part number for ignition coils? and prior to putting the boat in the shop, would...

Hi Mike. I got the runners yesterday. Thanks a lot. I was only expecting a couple.
got to love the bbc community!

greg

thanks for the feedback and lead on mud hole...I'll look them up

thanks I'll take you up on the offer for a couple of runners. PM sent

Has anyone owning a 2009-2012 F150 replaced the factory radio with a wireless carplay ready radio? what did you go with and can you post a picture. I'm especially interested in one that cover or...

Greetings - can anyone tell me of a suitable replacement for the guides and tip used on the older Duckett Micro Magic spinning rods? I have a couple guides that need to be replaced on a DFMM70MLS...

Greetings - can anyone tell me of a suitable replacement for the guides and tip used on the older Duckett Micro Magic spinning rods? I have a couple guides that need to be replaced on a DFMM70MLS...

Yes. I saw joe this past weekend.
Email sales@protecproducts.com

2012. And they are plastic :(

Greetings ford owners. Any word on why the 3.5 ecoboost valve covers are out of stock everywhere? Seems like ford or the manufacturer may be holding back the supply.

Hi dude. I usually stay at the quality inn in Lagrange. My fishing peers and myself never had an issue there but you’ll probable need to run your extension cord under your room door. It’s about...

Can someone identify the “noise” which looks like 3 crossing bars at 10ft out and 15ft down? They are present with the trolling motor minnkota maxxum at a stop Magnets from the TM??

533053​

Lebroc. Check them out