Yeah that’s about the only thing it can be. I was hoping I could fix it myself. Off to the shop. Thanks again.
Type: Posts; User: poleNhand
Yeah that’s about the only thing it can be. I was hoping I could fix it myself. Off to the shop. Thanks again.
. Thanks, so I tried that and no water came out. But the prop sporadically works. If I turn prop in reverse a half of turn it will spin and keep spinning. Once I shut off the prop I may have...
2020 Ulterra Ripetide prop won’t turn, but remote doesn’t show an error. The remote shows the prop turning. Any help would be appreciated.
Thank you 5keepers2. Don’t know why I didn’t think of YouTude. But it saves me once again.
I just got a new Marinco trolling motor plug male and female.It is a two wire setup. Without wires. And the male plug doesn’t come apart. Which means I can’t connect wires to it. Does anyone out know...
Yes it is as low as will go. The only option With this JP is drop the motor down to the last hole.
Its on 2022 Excel bay pro 203 not a bass hull but very similar to an Xpress hull. So you can tell me that you can’t help I will understand. But do those measurements sound right to you?
3B115505 is the S # 2022 pro XS 150. I have measured the transom at 21.5 in” from the top to the bottom of my pad. The motor is attached to a manual 6” Jack plate and is bottomed out. The motor is...
Does anyone know what the effects of a short shaft motor on a long shaft require hull? (Asking for a friend)
Thank you Wayne that is the one I ordered, good thing.
Solix 12 MSI G2. Serial number 19121703-0122 14 pin. I think I have it figured out.
I have a Solix 12 I think is g2. I need a transducer for it and wondering if a Mega ducer would work ?? I’m not sure if there compatible. Thanks for any help.
Thanks everyone for your reply’s Don thank you for the smart start info, this was where I was wrong. No cough at all made me think it was a starter issue but it was a weak battery. Thanks again for...
All seems good with the cables and connections. Motor is getting power, I can trim it up and down. Hoping Mercury will warranty the starter. Because everything thing else works. Can’t believe a...
Thank you I wasn’t sure where to post.
Actually this motor doesn’t give a warning beep if the kill switch is in the off position. I just double checked that.
Thank you I tried what you said but it didn’t work.
Yes I checked all the stupid stuff. Because I can be stupid. Neutral, kill switch, battery and connections. Just a click at what I believe is the starter. This motor has only been started a dozen...
My 2022 Mercury pro XS 150 serial# 3B115505 won’t start. I have checked everything I know. All I get is a warning beep and a click from the starter. I presume.
The battery has at least enough power to run everything else. If the battery was low it would try but fail to turn it over. There is nothing but a click from the starter , is my best guess
The kill switch is in the ON position. I wouldn’t get a warning beep if it was off. Thanks though.
My brand new 2022 Pro XS 150 S.N 3b115505 won’t start. I’m certain the battery is good. The warning beep goes off and there’s a click but it won’t even cough. Also I’m certain it’s in neutral....
Well ok then that belt is broken and fixing it or replacing doesn’t look easy. Any knowledge on that would be appreciated.
Has anyone else had the black strip come off? On an Ulterra, It’s on the flat side of the shaft. And what should I do to fix it? Thanks in advance for any help.
Both my foot buttons retract the Power poles. Can anyone tell me how to fix that? Thanks in advance for any help.