Search:

Not according to this product page.

https://www.garmin.com/en-CA/p/156004#additional

I don't think the Lakevu G3 Ultra Canada card has maps with high resolution relief shading.

This is the order of the wires ...

Side A
1 White/Orange
2 Orange
3 White/Green
4 ...

Hasn't LWINCHESTER2 had this for a few years now? Maybe he's been testing. :roll:http://www.bbcboards.net/showthread.php?t=979062&p=10225656&viewfull=1#post10225656

If you connected the GLS10, the 1222 and 93 all to a GMS10, the 1222 and 93 wouldn't communicate with each other but would they both independently communicate with the GLS10 providing a livescope...

Maybe silly suggestions but have you checked to make sure all the connections are secure? That there's no corrosion or bent pins on the connector? The only other thing to check would be damage to the...

I just looked back at mine and there was 3.5 months between the "received submission" and "rebate on the way" emails.

Yes, you can connect a thru hull transducer to the other unit for reading depth in plane. And you can try using this adapter to connect your Lowrance transducer but for full effectiveness, it would...

I think you can use this adapter: https://www.garmin.com/en-US/p/pn/010-11979-10

If you have more than one graph, you could run the GT56 to one and the GT8/15 to the other.

Looks like he has two 10" Echomap Ultras at the console, a 10" and a 12" Echomap Ultra at the bow, and of course Panoptix Livescope.

I think that's a Lowrance transducer, and the ferrite is there from the factory. Like you, I've always thought the best place to install that is right before the receiving device to reduce any noise...

I did a quick calculation, and most likely it will not pick up the barrel of the trolling motor. A 20 degree cone would need about 68 inches before it expands to a one foot radius.

Thanks bobcoy. Relion was actually the ones that made sure that I was aware of this limitation. On their spec sheet for the LT series it states "Maximum Modules in Series : 1 (Single-Use)".

Is anyone actually using a heated battery in their set up? When I last looked into this, I spoke with multiple vendors that told me a) their heated batteries cannot be wired in series, making them...

You can check what version you have on the remote under the "About" page. Here's a video in how to update the trolling motor software.

https://youtu.be/OweqVYKXIrE

Let us know if the issues...

Are you running the latest software? As you mentioned, it is indeed a safety feature but in earlier versions of the software, it is a bit too sensitive. In later software updates, they programmed it...

Welcome to Garmin. The GT54 does 2D, down and side. No need for the US2.

You are concerned about the Livescope being damaged but it's more likely that the battery will be damaged. Depending on which brand of battery you are using, there may or may not be a low voltage...

It because you have bottom lock zoom turned on. You can turn that off by going into the sonar screen, then MENU, then ZOOM and then turn off Bottom Lock.

Livescope works with the Plus 95SV. There are some people that find the performance of the older software versions to be better but I could never see the difference based on the settings I used. I...

That's a pretty typical readout for out of the water.

IMS is a user on here. Here's the thread on his mount so you can see the pictures.

http://www.bbcboards.net/showthread.php?t=1062217

I find the cone overlay on the map to be very helpful but...

The IMS one is a two piece design so you can adjust the angle to have it direct deeper or shallower in perspective mode. I tried playing with it a few times and didn't find it particularly beneficial...

Thanks for sharing. There must be a good story if you were searching for that. Or at least I hope it is a good story and not a bad one.