Search:

Type: Posts; User: jaystein21x

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    40
    Views
    2,114

    I didn't see where anyone addressed all the...

    I didn't see where anyone addressed all the emission add-ons to diesel engines nowadays. The ERGs and DPFs start killing those motors from the get go. Diesel engines do not equate to pre 2004...
  2. Replies
    2
    Views
    409

    Re: 2008 Trition 21 XS set-up (Rroberts47401)

    I had the same boat but an 07. I ran a 25 tempest and that hull likes the motor lower in the water. If remember correct, I was somewhere between 3.5" and 4" below the pad, not typical for other...
  3. Replies
    17
    Views
    2,311

    Re: Merc Monitor Install Options 08 19X2 (jentrick)

    http://www.bassboatcentral.com/smileys/thumbsup2.gif Glad I could help.
  4. Replies
    17
    Views
    2,311

    Re: Merc Monitor Install Options 08 19X2 (jentrick)

    That's correct, data is added as overlay data just like from any other device on the NMEA network if you have the correct level mercmonitor. Don Weed at European Marine is a board sponsor and the...
  5. Replies
    17
    Views
    2,311

    Re: Merc Monitor Install Options 08 19X2 (jentrick)

    Patrick, I would say no, you can't see it good there while running. And wouldn't be a good idea to even attempt looking while running head down, not a good situation. However, like I said, the...
  6. Replies
    17
    Views
    2,311

    Re: Merc Monitor Install Options 08 19X2 (Triton19x2)

    If you look in the lower right corner of the photo I posted earlier you will see where the Mercmonitor is located. I hope this helps. ...
  7. Replies
    17
    Views
    2,311

    Re: Merc Monitor Install Options 08 19X2 (Triton19x2)

    I have the level 1 mercmonitor, its has the white cover on it in the photo above the ignition switch panel. This gauge has the NMEA 200 gateway on it so engine data can be displayed on any NMEA 2K...
  8. Replies
    3
    Views
    372

    Re: 120 degree takeoff temp question (bh54lf)

    I would watch for the T-Stats to open. You should have 130 degree T-Stats and as the engine is idling the temp will increase to that point or slightly higher then see a decrease in the temp. 118 is...
  9. Re: 3L, XS or ProXS Rattling Excessively? ... (Tamale)

    My rattle is finally gone!!!! I had heard of this fix a while back and confirmed the rattle location by tapping on the mid cowling. I had the mid section off for the other maintenance and applied...
  10. Re: Replaced spark plugs today (TRCM)

    I thought the same thing, $9 is a really good deal for that plug. And a good bit cheaper than anything I found offered.
  11. Replies
    6
    Views
    965

    Re: Smartcraft pays off (Champion190CX)

    http://www.bassboatcentral.com/smileys/thumbsup2.gif The smartcraft gauge can save a person alot of troubles and money. Well worth the investment. If you didn't have that capability to monitor...
  12. Re: Replaced spark plugs today (taeheel2az)

    Yeah those plugs aren't cheap, but what is when you own a boat, that's the price we pay to enjoy this past time. Its really hard to say that those sparks plugs better days are behind them. By...
  13. Replaced spark plugs today (250 PRO XS)

    It's overdue but at the 100hrs service they looked like new, it was hard to drop the coin for new when they looked and performed flawless. So I continued on with the originals. I finally decided not...
  14. Replies
    5
    Views
    1,078

    Re: Found on port side??? (Bassmannnnn)

    It sure is!!! And I had a response within 10minutes of posting my question and my problem was solved. http://www.bassboatcentral.com/smileys/thumbsup2.gif I think I looked everywhere but there. ...
  15. Replies
    5
    Views
    1,078

    Re: Found on port side??? (jxb9723)

    Sure does. Thanks for the reply. I must have snagged the cowling and pulled off thanks again.
  16. Replies
    5
    Views
    1,078

    Found on port side???

    I found this laying at bottom of my mid cowling on the port side of the motor. 250 Proxs SN:1B692480. Anyone know where it may have come from? Cowling??? Motor??? I've had the mid cowling off in the...
  17. Re: 250 Mercury Optimax Pro XS (GunFish1)

    I would say any group 31 battery is the desired battery to meet all your cranking and accessory power needs. Don posted a recommended/approved battery list pinned above. I have a 31 diehard platinum...
  18. Replies
    21
    Views
    3,231

    Re: Puting engine in gear while towing. (jcma81)

    I leave it in gear when I trailer the boat. I just turn the key off with it in gear after loading. If the engine is off, it will take two people to do it safely, meaning no damage to motor. One...
  19. Replies
    92
    Views
    60,373

    Sticky: Re: Big Fish Pics! (ep72)

    Here are a few fish from the other day. 8 April 2010.
    http://i46.photobucket.com/albums/f126/jaystein21x2/8%20APR%202010%20West%20TN/DSC02299.jpg...
  20. Re: Don, I'm confused on my level 1 Merc Monotor / NMEA 2000 wiring (Baja 252)

    Baja, I have the same mercmonitor as you and all you need to hook up for the mercmonitor harness is the ground lead to the boat ground and the NMEA 2K into a "T" in the network backbone. Your NMEA...
  21. Replies
    5
    Views
    419

    Re: Anyone having any luck on Ky lake (Camaroboy)

    Fishing is good. 100 fish day if you don't mind catching the small ones on secondary points. We found few schools of big fish but they were all still at the mouths of the bays in deeper water. ...
  22. Replies
    4
    Views
    226

    Re: Question water pressure (cmpky)

    Chances are your poppets working since no overheating exists, but the pee hole elbow has a clog. The pee hole is for a visual confirmation that water is pumping. The cooling system should still...
  23. Replies
    40
    Views
    1,744

    Re: New Sweatshirt Order (Charger)

    I received the shirt. Thanks, Matt.
  24. Re: Sweatshirts Ordered Please Send Pay Pal (Alliston64)

    Paypal sent. Thanks!
  25. Replies
    30
    Views
    10,324

    Re: Regarding Ignition Coil Failures (BADAZZTRITON)

    Badazztriton, I'm happy to say Mercury did replace all six coils this time around with the new coils. I know my dealer went to bat for me and pushed Mercury for all 6 to be replaced, so hopefully...
Results 1 to 25 of 93
Page 1 of 4 1 2 3 4