Search:

Type: Posts; User: 99intimidator

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    127
    Views
    10,983

    Just found out about this today mines in the shop...

    Just found out about this today mines in the shop getting the fuel pump replaced. They said that they did the recall. I'll be removing mine looks like the fake vents you buy at autozone. Mercury...
  2. I think its on the newer motors that are having...

    I think its on the newer motors that are having the problem. The only things that I see different is they added holes to the lower unit and a different exhaust water strainer. I haven't ran it since...
  3. So there is more engines having this problem I...

    So there is more engines having this problem I have smartcraft gauges on mine I only see .4 on the water and ran it in 100 gal water tank still same reading. When I had it in the tank I hooked the...
  4. Replies
    41
    Views
    3,065

    Just picked mine up yesterday had 2014 Pro Xs 250...

    Just picked mine up yesterday had 2014 Pro Xs 250 before. Did the two hour break in yesterday like trying to hold back a race horse. Everything is better on this motor hole shot, mid range and top...
  5. Mine stick all the time but what I found what...

    Mine stick all the time but what I found what works for me. I put the motor in gear and run the motor 1500 to 2000 rpms. When the motor gets to around 120 degrees I shut it off . Then I just watch...
  6. So the Optimax isn’t good motor to use in...

    So the Optimax isn’t good motor to use in saltwater?
  7. Replaced all the air injectors , compressor and...

    Replaced all the air injectors , compressor and fuel rails . I did the break in way of priming the oil system. I don’t know how much this limits the power . But what a difference the prop I had on...
  8. Just priced all the parts for the fuel rail and...

    Just priced all the parts for the fuel rail and added what it was going to cost to test and clean the injectors. Figured I would be better off this motor was used in saltwater and has some corrosion.
  9. Just found out all six air injectors are bad ....

    Just found out all six air injectors are bad . Took apart fuel rail and found what looks like carbon buildup up where the diagram sits. What would cause carbon to build up there ? Really wasn’t a lot...
  10. I pulled the reeds and seen some scoring on the...

    I pulled the reeds and seen some scoring on the cylinder wall . Doesn't look like a lot of metal went through the system. I pulled the rails and injectors to send in and get them cleaned and tested.
  11. 2014 250 PROXS AIR COMPRESSOR VOLUME TEST

    I have a 2014 250 proxs serial number #2B017902. I noticed a loss of about 600 rpms or more. I was checking the fuel and air pressure both are just a little low 90 psi on the air and 104 on the fuel....
  12. Replies
    17
    Views
    1,000

    I had the same problem with my 2014 250 PRO XS I...

    I had the same problem with my 2014 250 PRO XS I noticed that it looked like the bolts that hold the mount broke first. Be sure to get the updated part number bolts that hold the cover over the...
  13. I had a 97 225 EFI for over 10 years had to...

    I had a 97 225 EFI for over 10 years had to replace the stator one time. That was the only problem I ever had. If your happy with your EFI and want to do I few mods it would be cheaper than buying a...
  14. Replies
    2
    Views
    288

    You might check with Simon Motorsport he can...

    You might check with Simon Motorsport he can repair a lot of the problems with the ECU.
  15. Replies
    4
    Views
    705

    I’m running Premium Plus the picture I have of...

    I’m running Premium Plus the picture I have of the top of the intake shows oil around the top of it where the throttle body mounts. Don’t know how oil could get up there.I don’t have a transom saver...
  16. Replies
    4
    Views
    705

    250 PRO XS OIL LEAK

    I have 2014 250 PRO XS serial number 2B017902 that has a small oil leak. There is oil by the throttle body and map sensor. I checked all the hoses on top of engine no leaks. I pulled the Map sensor...
  17. I always wear mine but the kill switch isn't the...

    I always wear mine but the kill switch isn't the big problem. It's those tunnel hull bay boats just google the Dangers of Texas flats boats. They need to do more testing on the tunnel boats before...
  18. Replies
    10
    Views
    2,282

    I have one they work good out of the box. The...

    I have one they work good out of the box. The only problem I have is that mine likes to break loose on holeshot. I can turn a 26 bravo to 6100rpm but my Scorpion 24 I do good to get 5800. I think a...
  19. Replies
    17
    Views
    1,358

    Tested the new prop today it does everthing...

    Tested the new prop today it does everthing better than the xs except the holeshot. The holeshot isnt too bad but just not as good as the xs. Thanks to everbody on here that steered me a way from the...
  20. Replies
    17
    Views
    1,358

    Alot bay boats are made for speed SCB, Lake N...

    Alot bay boats are made for speed SCB, Lake N Bay, Majek xtreme and there are alot more. I've seen a bunch with the 400r Mercury.
  21. Replies
    17
    Views
    1,358

    I think there is a few more mph in the boat still...

    I think there is a few more mph in the boat still have 20 psi of water pressure when the bravo starts losing speed. They say that a pro max prop will give you the best top speed on these boats. But...
  22. Replies
    17
    Views
    1,358

    I have prop coming that is a bow lifter and made...

    I have prop coming that is a bow lifter and made to run at high engine height I'll see what it does.
  23. Replies
    17
    Views
    1,358

    I have 24.5 bravo also for when I'm loaded it...

    I have 24.5 bravo also for when I'm loaded it actually is any better than the 26. I guess I was lucky on my Trophy that I had before ran it for years and never lost a blade. It was faster than the...
  24. Replies
    17
    Views
    1,358

    It's a 22 flats boat with a 250 ProXs just seems...

    It's a 22 flats boat with a 250 ProXs just seems hard to keep the bow lifted. It's real hard to find the spot where it runs the best. I had a trophy on my old gambler it seemed to have more bow lift...
  25. Replies
    17
    Views
    1,358

    I want to run higher on my jack plate the bravo...

    I want to run higher on my jack plate the bravo starts to lose speed when I go up still have plenty of water pressure.
Results 1 to 25 of 67
Page 1 of 3 1 2 3