The rubberish bow panel on the Z9 is starting to split and break. There's not much information on replacement panels for the early Z series, Z7, Z8, Z9. I did find a company that makes a...
Type: Posts; User: r_marczak_83
The rubberish bow panel on the Z9 is starting to split and break. There's not much information on replacement panels for the early Z series, Z7, Z8, Z9. I did find a company that makes a...
Indeed correct. A new 1000cca is what was needed. Works great now.
2014 nitro z9 with Mercury 250 two stroke. Always starts fine….. until now.
Went to take it out and the trim wouldn’t come up. BAD BATTERY. No prob. The boat has 5 batteries on it. 1 is starter and...
Thanks all. I’ll schedule the maintenance on it this winter then, since that’s it’s down time.
I will check jack plate height as well.
Good info here!
I just bought the boat off an individual and do not know when they last did it.
I had a mercury 90hp for 7 years and didn’t have a water pressure gauge. I always watched the pee stream. Now I have a 250 proxs and it has a gauge.
I have a strong pee stream, but the pressure is...
Check the wires at the tank with a meter and make sure the ground is tight, plus that it has a voltage reading of something other than 0v on the ground to the "signal" wire.
I have a broken plastic trim piece on the back of a 98 700lx. I measured it to get a replacement and the total length is 23-24". Online all I can find is 33 1/2' up to 37'. Also the width is 1 3/4"...