Search:

Followed your steps and it appears the warning module is bad. Now to find the module to buy somewhere.

Thanks, now to try it out.

Thanks for the awesome steps! I'll give them a try.

Where is the warning module? (Under the on motor oil tank behind the lower cowl pictured below?)489723

Where would that be located? Could it be the buzzer, because I had to tap on it to get it to work once too.

Tried that. Still a constant beep as soon as the key is turned on.

So my warning buzzer is going off constantly upon turning key on, whether or not the motor is running. It had not been doing its initial key on beep unless I cycled the key a couple of times. Any...

Thanks for the offers. I just dropped a Trophy on it this morning, but it will have to wait till i get back from a trip to try it out.

So far this one has been a breeze. I have only had to clean it once and the spray it yourself carwash took care of it really good.

I used the Duplicolor Bed Armor Kit. It was awesome. Used about half a gallon to go over most all of the trailer with 2 coats. Did it back in Feb, and it still looks as good today as it did then.

That would be nice too Mike, but at this point, i dont care what i can get. Mark repaired the Alum prop i have now over a year ago and it has performed awesome, but it has done the same thing again...

I am in need of a used 21P 3 Blade for a Merc Motor in aluminum or SS. It would have to have the smaller diameter barrel to fit my '95 Merc 75hp. I would try a 22/23P aluminum, or down to a 19pSS.
...

63681 Bed Liner on and Dry, along with all other things. Time to put the boat back
63682 Boat is home and the trailer is looking GOOD!

Realized i forgot to put up pictures of the trailer Restoration now that it is completed...


63676 Starting to sand the rust off and get all the old paint cleaned up
63677 Boat is off
63678More...

I will be staying in Branson MO May 12-18. Planning to bring some tackle because the place we are staying has a private pond and the vehicle we are using can't tow the boat. Wouldn't mind meeting...

I will be staying in Branson MO May 12-18. Planning to bring some tackle because the place we are staying has a private pond and the vehicle we are using can't tow the boat. Wouldn't mind meeting...

As good as they look in the pic, they are so much brighter in person!

Looking good. The back red LEDs on the trailer made it look sweet as you left with it.

I had forgot about this, Email came back quick, and so did the replacement rod! and it is nice!

Once again, you are right on the money. Not sure what the issue was, everything seemed to be tight, i put the wrench to everything and made sure of it, and found no burnt or loose connections. It is...

thanks Don, i will report back if that does not resolve!

So, a couple trips back, i noticed my Tach was not reading anything. At one time in the past, i had to move the selection switch on the back some and then back to the factory setting to get it to...

i have the same issue going on with mine. I have narrowed it down to the livewell drain line. I did this by putting the plug in the boat, then starting to add water to the hull, once it gets up...

Just broke one yesterday on a hook set, so i just sent that address an email... hopefully i get a response soon.

what is the 3rd hole going to be for under aerator system?

Thanks for the info. I was thinking about going with Raptor Lining, but it seems it will take 2 kits (double the price) to do it with it. 1 kit is great news. did you do the inside of the C Chanel...