Search:

Type: Posts; User: EuropeanAM

Search: Search took 0.07 seconds.

  1. Replies
    25
    Views
    566

    Should be very close. Make sure you set the...

    Should be very close. Make sure you set the timing pointer (using a dial indicator) before starting.
  2. Replies
    25
    Views
    566

    You will need to perform a COMPLETE Sync-n-Link...

    You will need to perform a COMPLETE Sync-n-Link Procedure, per the instructions in the manual. Mandatory any time the carbs have been loosened or removed (same for the trigger, removal of the idle...
  3. Replies
    25
    Views
    566

    Not necessarily... Problem will be in the...

    Not necessarily...

    Problem will be in the switchboxes (ALWAYS replace IN PAIRS), or the trigger. Switchboxes are more likely if it's a SINGLE cylinder down.
  4. Replies
    25
    Views
    566

    Usually trigger will affect 2 cylinders when...

    Usually trigger will affect 2 cylinders when there is a problem in a winding.

    You said that you swapped the wires and swapped the coils. Did you physically remove the coil, and move it to...
  5. Replies
    25
    Views
    566

    Don't overlook the GROUND for the coil... and...

    Don't overlook the GROUND for the coil... and when you make a jumper, make certain BOTH ends of the original lead are disconnected.

    Does this engine still have an idle stabilizer installed?
Results 1 to 5 of 5