I figured it out.
In case someone else has this problem, the correct thrust washer is Mercury Marine part number 75282.
Type: Posts; User: Bill Reynolds
I figured it out.
In case someone else has this problem, the correct thrust washer is Mercury Marine part number 75282.
This is normal. The motor grounds through the transom bolts and the negative terminal is grounded to the motor block.
This is a high impedance connection and will probably not support current flow...
I’m getting concerned about our timing. I wish we had scheduled for next week instead of the week after.
Hope we don’t hit post spawn conditions.
Thanks, I did not read this carefully enough. My Bad.
I live in a moderate climate so I can choose when I charge my batteries but this brought to mind another question. I know the outside temp, but...
I don’t have any experience with the Motor Guide but I have had an Ultrex since 2018. It has been flawless.
Minn Kota had a problem with the foot pedal pressure switch in the first year (2016) but...
I bought an older version of the LaserII 20 pitch prop with the intent of running it on my new Mercury 115 4 Stroke.
It is part number 48 16990 A40 20P it has a pressed in hub as opposed to the...
Lowrance does not repair or trade out any unit older than 5 years. They also do not sell repair parts so even a company like Clear Cast has to develop a source for used parts to do any repairs.
I...
I replaced a 2008 F150 Lariat Limited with the 2020 Tacoma TRD Sport after a lot of research and it has performed about like I expected. It handles the hills around Hot Springs well but downshifts...
Not dual mount but I had a 12 inch HDS on the bridge mount shown that I replaced with a 9 inch Garmin but later changed to a 10 inch Garmin. I raised the Garmin up for better viewing.
I tried...
No. They provide + 12 volt power to the trim relay coil, the circuit goes to ground through the relay.
These two wires go back to the shifter and connect into the motor circuit with bullet...
I bought the Boat lanes and loaded them to my Console Garmin unit today. Thanks for that recommendation, I scrolled around and saw the trails. I have tried navigating the buoys on LOP and that was a...
Presently, the battery cases are sealed so you are not able to replace the BMS even though they are available for purchase. Obviously the DIY guys do it but most people do not like to tinker that...
hook it up in Parallel with the other battery, pos to pos and neg to neg and leave it 24 hours.
I’m not sure if you can view multiple shunts on the app but it powers up to a screen to select...
I had the same thing happen, lost both caps 90 miles from home and was stranded in the ramp parking lot. I left the boat and trailer and drove into town to a trailer repair shop. They sold me the...
How did you do the printing on the black box?
I use this on my 24 volt setup and it works great. It does not show individual battery parameters so I check individual battery voltage every 6 months or so and if it is .2 volt difference, I...
Thanks for posting. I have two 50AH ReDoDo powering a 80# Ultrex for about 3 years now. I have not had any problems but I see a lot of posts about BMS glitches of all brands. It doesn’t matter how...
If I were to buy today, it would have to be gas because of Range anxiety. However I think that will go away in a few years as the charging infrastructure improves.
Here’s an example. My son bought...
This ^^^^^ I am just a weekend guy but been fishing club tournaments for 45 years so I have seen all the fishing aids develop. I have had FFS for over 3 years and I see it as another tool, basically...
Thanks, I will keep on touch as the time approaches.
Thanks Guys I really appreciate the information. Glad to hear they will be shallow and I love to throw a frog.
We normally go to LOP but wanted to try something different.
A safety question: on...
We are planning a trip to the Mill Creek area of South Toledo Bend on March 18-22. We will be in my little Tin so want to avoid main lake if possible.
First time on that part of the lake and don’t...
My DIY motorized Transducer Pole designs mostly focus on trolling motor mounting brackets but that only works if you have an Ultrex, Ghost or Force.
When I built the first one, I had a Minn Kota...
If you are a prime member you can set a Normal delivery day in your profile and this will be a delivery option when you check out a purchased item.
I do a lot of DIY projects and often need small electrical or electronic items that I can’t find anywhere else. I can get a $5 item delivered tomorrow and it is not unusual for me to order different...