Search:

Type: Posts; User: lpugh

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    5
    Views
    94

    Note the yellow circle, bullet connects 2 gray...

    Note the yellow circle, bullet connects 2 gray wires?
    Customer got terminator from the A, no color markings, just noticed pin locations are different, I will find a mercury one for it.

    546395
  2. Replies
    5
    Views
    94

    No cable to front of boat, terminator lower left,...

    No cable to front of boat, terminator lower left, vvm lower right in first picture.
    Notice the second pic. gray wire and brown/white spiral stripe wire connected to the diag port? Not connected to...
  3. Replies
    5
    Views
    106

    Sure will

    Sure will
  4. Replies
    5
    Views
    52

    Is the seal in place and good that goes on top of...

    Is the seal in place and good that goes on top of the high-pressure pump that seals it to the vst top for the fuel outlet?
  5. Replies
    1
    Views
    83

    What are these wire's for?

    Connected to the diagnostic connector, the other ends no connected!
    This is the same motor in the post about no RPM reading on the vessel view mobile.
  6. Replies
    5
    Views
    94

    Vessel view link, no RPM

    1B071442 . Vessel view mobile (not link)
    All other data is availble, Diacom shows no faults and RPM, bad unit maybe?
    Factoy analog tach is erratic and very false RPM with motor running, using the...
  7. Replies
    3
    Views
    171

    controll box removal

    2004 Cougar, I see no access to remove the shift assy. Looks like I need to cut a larger access hole where the LiveWell control panel is, my 02 cougar is all open in that area.
  8. Replies
    7
    Views
    386

    the flat has rolled over, ball side is up

    the flat has rolled over, ball side is up
  9. Thread: clean power

    by lpugh
    Replies
    11
    Views
    336

    Duplex is just 2 wires not twisted in most cases...

    Duplex is just 2 wires not twisted in most cases in a sheath
    I make the stainless straps and post adaptors myself from stainless straps, I have a milling machine, can also be made with a good drill...
  10. Thread: clean power

    by lpugh
    Replies
    11
    Views
    336

    ^^^^^^ +1 this is how I do them, stainless strap...

    ^^^^^^ +1 this is how I do them, stainless strap double duty wrks as a mount an connector
    545956
  11. 1. test battery SOC and condition 2. voltage...

    1. test battery SOC and condition
    2. voltage drop from battery positive to power point on motor
    3. drop test form battery to a good to motor block and starter case
    Battery post not the connector...
  12. Thread: clean power

    by lpugh
    Replies
    11
    Views
    336

    Here is a guide line for you, note the twisted...

    Here is a guide line for you, note the twisted pairs, very important for clean power.
    No duplex wiring please unless it is prefabbed twisted, 3 to 5 twists per foot.
    545929
  13. ^^^^^^^ Plus 1

    ^^^^^^^ Plus 1
  14. Thread: Fury 3 to 4

    by lpugh
    Replies
    3
    Views
    138

    The Fury 4 will soon become a badly out of...

    The Fury 4 will soon become a badly out of balance Fury 3:laugh:
  15. I am not guessing, battery bad or insufficient...

    I am not guessing, battery bad or insufficient for the job or both.
  16. fill all the way to top, trim motor to get last...

    fill all the way to top, trim motor to get last little bit of air out.
  17. 2 screws hold a stainless clamp Brackett in place...

    2 screws hold a stainless clamp Brackett in place that retains both lines ( 5/32 hex Allen head)
    Then line are pushed into the rails, the O-rings seal that connection, they will be stuck in there,...
  18. Replies
    8
    Views
    363

    Looks to me like 2 problems, Down scan overlay...

    Looks to me like 2 problems, Down scan overlay set way to high and surface cluter setting to low
  19. Replies
    14
    Views
    427

    How do you know it was an low alarm?

    How do you know it was an low alarm?
  20. Thermoset stuck open, idle for 5 minutes without...

    Thermoset stuck open, idle for 5 minutes without reaching 120 degrees will set a code and a 4 beep alarm.
    Scan computer fault history will confirm if this was the case.
    Got to those temps, cold...
  21. Replies
    13
    Views
    198

    Not for a bass boat, that is bare minimum, no...

    Not for a bass boat, that is bare minimum, no electronics, LiveWell's ets. REcomend 950 CCA and 185 minutes reserve capicity at least. Some guys with larger and more graphs need even more
  22. Replies
    13
    Views
    198

    When does not start is what is important to us.

    When does not start is what is important to us.
  23. compression test first thing, got to make sure...

    compression test first thing, got to make sure the motor is sound before making other repairs.
  24. Replies
    13
    Views
    198

    When it does not start do you hear single beep at...

    When it does not start do you hear single beep at key on?
    I would start by checking the master power relay for proper operation when in failure mode.
  25. Replies
    4
    Views
    95

    Cannon plug key switch neutral safety switch...

    Cannon plug
    key switch
    neutral safety switch
    solenoid
    electrical connections
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4