Search:

Lesson learned. I have never had this work done to my prop before. I hope something can be done.

Not sure about slip. All I know is that my motor ran fine but my speed was 5 mph slower than before I had it repaired. Its got to be something with the way it was repaired. Maybe cupping is off. ...

I will. Already called and left a message. Thanks!

Mike Hood Marine in Houston. Not sure about the cupping. I have no jack plate.

Raise the motor as in trim up when on plane?

Ok, so I got a tempest 2 26. My blades were chipped a little and I sent it in to be reworked. Got it back, it was beautiful and seemed to be great. I put it on with a new flow torque 2. Took it...

Tried to reach out to Jones today. Apparently John??? Maybe...doesn't work there anymore and this place don't sell motorguide parts.

Any idea what size that (short) toe connecting cable is from tip to tip? Not the housing, but from end to end of the wire? Thanks!

Ok, here is another question that i am concerned about.
I have to replace the cable that is hooked to the heel of my footcontrol. I measured my black cable housing and it was 63 in. Assuming that...

Help! I had my boat in the shop to test coils. I figured that problem out and now my service guy sends me the message below saying I need this PTT bottom bushing. Anyone know where this is and why...

Definitely agree!

Hummm...good to know. Thanks!!

Yes sir, and no YouTube vids out there. Thanks!!

Wow! Thank you very much. This is why I joined this forum. I will be doing this when my 63 in cable comes in this weekend. I will let you know how it goes. Again thank you!

This cable hooks to the back or heel of my trolling motor. Thanks.

Yes, the steering cables that wrap around the head. My short cable is 63. At least that is what I was told for my motorguide tour. Great illustration. Will definitely be using this. Wonder why...

Ok, so I changed out the ignition coil and the drive coil on my 2006 150 optimax today. Yes, you have to take off the coil plate to do this. The coil driver, and coil is attached to the plate by a...

Thanks. Basically didn't want to open the head up without a plan. Going to try to tackle the project this weekend. I'm assuming that I will need to wrap the cable around the head. Does it show...

Looking to replace a broken trolling motor cable on my motorguide tour. Its the 63 in one. Any one ever done this that can send step by step instructions. Yes, i did look on YouTube. No, I can't find...

Looking to replace a broken trolling motor cable on my motorguide tour. Its the 63 in one. Any one ever done this that can send step by step instructions. Yes, i did look on YouTube. No, I can't...

I have a 2006 mercury optimax. It has a bad coil. Trying to take the coil driver off to replace the coil doesn't seem to look very difficult, but the bolts just spin. Am I doing something wrong? ...