Search:

First check the power in wires to make sure you're getting full power with the trolling motor set to 100% constant. If so, check the power out wires and see if you're getting full voltage out. If...

I dont remember seeing the pm. can you shoot it again. btw, will be out of pocket for a couple of days, but will get back with you.

Just saw this. Usually look for post down in the bottom part of the page or PM me, but welcome to the boards. I have either prop. They are in the $35.00 price range. Call us at 870 773 3474 to...

A bent pin will cause noise.

That's your call. A new three bank will take up less room than your two bank and a single bank, but a single bank will be less expensive at this time.

Both have their advantages and disadvantages. Mine has a plug. If it ain't broke now, I wouldn't "fix" it. However, when you get to having plug issues, consider direct wiring. When you do, you...

Don, on a Terrova, you don't change shafts. You order the shaft already bonded to the center section of the lower unit. They all come the same length but don't remember if it's 72 or 60" -- I'm...

Sounds like the knob is stripped and not allowing the potentiometer to turn. If so, replaceing the knob is the solution. We have them in stock.
John

Best advice is it's time for a new trolling motor. There are no parts available for yours. Even if you go through the troubles of diagnosing, there is no parts unless you find something else used...

Welcome to the boards. This isn't the proper way to troubleshoot. You're just reading battery voltage, which a single strand of wire could carry. You have to check voltage when under a load before...

Yes

You can use either. Look at how the arms are going to be effected by the sponsons on the boat. I like to use the lower holes if possible to raise the mount as high as I can. then adjust the depth...

At wide open, it can be check on the positive wire, between the battery and the positive cable.
John

As a motor ages, it "can" get weaker due to connections, magnets, wiring, control board, and prop condition. It can be checked by taking an amp reading with the motor in the water and the trolling...

I can get these parts, but to get prices I need the shaft length of the trolling motor. There are two different mounts, one for the 42/45" shaft and one for the 52/62" shaft.
Thanks
John

Yes, they are in there with locktite (blue). I'll get you prices later today. Thanks
John

If you're comparing trollingmotors: ie 80# vs 80# (Maxxum doesn't come in a 112 and Fortrex doesn't come in smaller than an 80#), there is not a difference in trolling motors, just the mount and...

Did you know that Jones Trolling Motor does more than just trolling motors. As a dealer/ASC for MinnKota, we also sell/repair Talons and sell the MinnKota chargers. We are a dealer and authorized...