Search:

I guess I gut lucky with my advice...LOL

I had this EXACT thing happen on the first SHO I had. I broke it in using The Yamaha break in procedure. I sucked out the extra oil via the dip stick tube until oil was again between the low and...

I would roll with it. However, I would check oil and oil condition, pull lower gear case drain screw and check for water and excess metal on magnet. Also keep an eye on your water pressure gauge. ...

I agree!

Use something like this

Magnetic Boat Trailer Surge Brake Lockout Key, with Easy Release Strap,

Man, I am going through the EXACT same thing with my seals leaking! Every season I have 1 start leaking. Last grease seal leaking I did replace with a Timken seal #470460. Hope it last better then...

Yes everytime I change seals I replace wear sleeve.

Problem motors where in the very early years 2009-2011. Been great since!

Only problem I keep having with the Vault system is not being able to keep grease seals from leaking every 1-2 seasons! i HAVE TRIED DIFFERENT SEALS. this LAST TIME i WENT TO A TIMKEN SEAL...SEE...

I think most likely your just being more aware because of slamming on the brakes. Like said before if they where really dragging to much then they would be too hot to touch!

Also check this guy out!

https://www.rudolphrepairs.com/

https://www.youtube.com/channel/UCcFHAWCH83Z3vwxJ0BV1H4Q

No they offer a reduced rate on upgrading units as well. Call Lowrance!

https://fishobsessed.com/collections/quest-series-transducer-mounts-lowrance-active-target

Never have an issue with my 2015 ZX 250 as long as I trim down BEFORE slowing down to come off plane.

I ALWAYS use bait casting equipment for neko rig and senko fishing! I use clear silicone band and have absolutely no issues.

That is why all my electronics are run to a master cutoff switch . So I have best of both worlds!!

This is what I used

https://www.bluesea.com/products/713...face_Mount_30A

I personally wire the yellow wire on the AT module to the yellow wire on the Live unit I use for Active Target (I have 2 Live units at the bow). That way if my Live is on my AT is on. In contrast...

Sounds like a problem with the BMS. Lately it seems a lot of BMS problems.

Marc, when you "restore defaults" do you lose waypoints?

If it is a torsion axle then no.. Its a bolted on and you can change them for about $300 and about an hour.
...

THIS!!!! Heading up!

Thats the one I use as well. I like it a lot!

Mouse chewed through master power switch wire.

Fuse for master power blew or corroded in fuse holder.

That's the head that Elite Series angler Cody Huff uses. And that's his deal.