Search:

make sure are plugged into channel 2 in the back of the unit, it is the black port beside the blue 2d transducer port. also make sure channel 2 is turned on in the menu

NMEA does not share transducers. the only way a ti2 will read a transducer is if it has one plugged directly into it. ti2 will how ever share 2d wirelessly from another ti2, but no other unit

yes and no, point one is nmea and will share way points of all units are on when waypoint is saved. ethernet will sync way points when units are powered on. i would run both to have the best of both...

why not install a transducer board that way if you need to adjust the transducer or change transducers later on you are no putting additional holes in the transom?

Countryside bbq sauce here... best out there

.

Replacing the hook line of units is my guess

correct same as the live and pro units

Custom depth shading is compatible with Lowrance HDS Gen 2, HDS Gen 3, Carbon, Live, Pro and Elite Ti and Ti2 and Fs units. not compatible with hook units

sandylee, you do realize for the side imaging fish reveal to work you still need the s3100 box? hope you purchased that as well. pro units require it also

that is not a mercury tag,,, it is a tag that the seller has put on the filter for their own selling purposes. i would bet that their computer system require to put a expiration date when making the...

No, internal maps do not share, only map cards share to all units on the network, must be hooked through ethernet to share

i think Don answered this for you already on the mercury engine forum

Gateway module does not offer this feature. It is an outdated device, which provides ONLY DATA (it does not offer VesselView...

if you are running a 3-1 transducer you need to stop sonar on 2d and on the side\down imaging pages fro the transducer to not click any more. just hitting stop sonar on say the 2d page will not fully...

do not level with the tm head unless your tm head is level when in the water and i very doubt it is perfectly level then. remember you boat does not sit level when in the water and neither will your...

i would say that is for sure your transducer is not set correctly. is it on a pole or mounted on trolling motor? remember that your pole or tm should be level when in the water, if it is not you may...

still pug and play. hours and all other info will be read off the engine it is hooked to so shouldn't be an issue

after taking a 2nd look at the pics looks to me like the trim pin is installed backwards. the slotted part of the pin should face out, not towards the digital trim sender.

trim sender is more than likely installed backwards. does your trim gauge read correctly?

Arrow is the direction of fuel flow from the tank to your engine, vertical is how you mount the sensor. So sensor mounted vertical arrow will point up. for the most accurate reading mount near fuel...

looks like the trim ram pin bolt. trim engine up and verify trim pin bolt is still there

there is not a system shut down for the active target box like there is for a head unit. you shut off power to your unit it shuts off power to your box after your unit is completely shut down. no...

i have rigged several active targets and always put the box on a switch. red and yellow wire together on a switch. the reason i do this is for the fact most dont always use the active target when...

make sure channel 1 is turned on in the settings.

all bruswick owned companies are down due to a computer security concern have been since at least monday. not sure when they will be back up and running