Is there a hub kit to install a 24 pitch raker 2 prop on a mercury 250 4 stroke?
Type: Posts; User: jtts
Is there a hub kit to install a 24 pitch raker 2 prop on a mercury 250 4 stroke?
ECM motor no capacitor. You’re going to need a motor tester. It could be motor it self,the drive assembly or board. Only sure way is a motor tester. Motor and drive assembly are expensive on these...
Just picked up a 2021 520C with a Mercury 4 stroke 250 pro XS. Two questions what prop are you guys running and what have you found for best prop to pad height. It has a manual jack plate. Currently...
Can anyone answer a couple of questions on boat titles and trailer titles in North Carolina? Trying to buy a boat there and Iam from Michigan. Please pm me if you might be able to help. Thanks
Call delta they will send you parts no charge.
In Michigan when I run my beagles to train for field trials I have to have a small game license.
What bearing system do I have? Need a seal replacement oil and brake pads. Anyone have any ideas.
Can you post rangers directions?
​
I just finished 1200 square feet of ceiling and I put 1/2 osb first. That way you can nail anywhere. You also have zero scrap.
At 70 feet on natural gas you can only get 38000 BTU ’s.
specs on your grill show it is 80000. Need a minimum of 3/4 inch pipe depending on what type of pipe and number of 90’s.
1.40 here in northern Michigan
Update replaced y cable and all is good now.
It’s a old one . It was originally on the boat with the onix with the 2 transducers. Going to order a new one. Only thing it could be. It works with the onix still.
Already checked that. Its like the y cable is bad but it works with onix .
Installing a Solix 10MSIG2 using Y cable 490420-1 , in hull transducer XP1420T and transducer XM14HWMSIT. Problem is I can not get a temp reading or the side imaging transducer to work. I can plug...
Mine came with transducers. When I sent my onix’s in they wouldn’t come off the loading screen. That was after trying to update them. Bad part was mine were both recessed and the solix are a...
You will more then likely get a solix back. I have sent in 2 ONIX 10’s and received 2 solixs back. Bad part is if you are networked the ONIX and solix won’t work together because of different...
Here was his response. Hey Joe! Good hearing from you! Been a busy season already. But a good one! Thanks for sharing that. We have actually discussed this exact situation. Baits, line or...
Sent this thread to tournament director at MLF. They have already discussed this and you will more likely see it addressed in future shows.
Pull toilet ,set on 5 gallon bucket, fill tank and try and flush. Good way to rule out vent problem.
Anyone know if that part number will work with a Evinrude G2? It’s on 2015 Z 520C.
Never turned them when trailering. No problems. Just make sure you turn when running on the water. Snapped pole right off back of the boat once. Learned the hard way. Amazingly power pole covered...
I have a 2015 G2 250 that is the same way. It does not have power steering and it has 2 to 3 inches of movement. Been back to dealer 3 times and power purged each time. Evinrude rep is supposed to...
It is below water level.