It don't even have all the bells and whistles. Not to bash it but at that price I shouldn't have to buy another accessory to add to it.
Type: Posts; User: bassmastrbw96
It don't even have all the bells and whistles. Not to bash it but at that price I shouldn't have to buy another accessory to add to it.
Seen it at the classic today. Nice boat but 133k fully rigged 😬
I'll send pics tomorrow
I have a one that needs restoration comes with trailer I'm thinking about selling it has a 250 pro xs I'd part out or sell whole. I can email pics if interested.
Here is a link for like for like replacement.
https://www.mcmaster.com/90265A149/
I already have an on-board charger for all of my batteries on the boat I only spent about 50 bucks rigging it up
Like I said either way is a good route. I just prefer more voltage. as far as buck modules being waterproof I mean sure they can stand to get a little damp I wouldn't hold a pressure washer on them...
Only issue I have with that route is it's only 12 volts. Yes it will run fine, but the unit shuts off at 10v. My thinking was I'll have a 36v supply reduce the power to maximum unit voltage. It will...
Only filter you need is on line power from battery. Then use buck module to reduce power to desired voltage. No need to filter anything on the transducer. I would rubber mount it though. That will...
Here is what I used
Graphs are at 18v
Panoptix is at 30v
...
If done properly minimal noise will reach unit. A low output noise filter at the buck module then the supplied magnets at connections. Works awesome have plenty of reserve power.
I run mine off my 36v system then use buck modules to reduce voltage to highest recommended voltage for each.
Does anyone know off the top of their head what the thread pitch of the shoulder bolt is and length?
Amen to that. Nothing a like strong will and power of prayer.
Prayers sent for Hudson.
Looking for a 30 bullet cut performer 4 does anyone have one they'd part with?
If it's single ram trim I'd go with 10 degree wedges and a 26 bullet cut performer
Hey I'm Looking for a bullet cut performer, bravo 1 or a hydromotive 28.
What i done was run 6ga at 36v to a terminal block. Then I got two buck modules and ran 32 volts to live scope and 18 volts to head units. Seems to work fine.
Ok thanks sir I'll try that tomorrow.
Today i found some fish on some stumps. I had them on sonar and down scan. When I scrolled back down image then clicked on the fish and to Mark them it placed a waypoint at the boat. Is it possible...
I'm building a pole Mount now. Elder aluminum fiberglass shaft. I'll keep updated
Here is the link to the $200 Garmin rebate
...
Hey guys I just posted a link in the lounge section Just passing on a pretty good deal that I have ran across I think.
http://www.bbcboards.net/showthread.php?t=1093501
Hey guys just going to share a deal with you I found. Rakutan has a 15% off link at Bass pro shops today only and they are running a special on their Garmin units. I just purchased a 106 SV and two...