Can you get a new transducer or get it repaired? When deployed the transducer cable broke wire ties and got caught. The lowrance Elite FC 9 quit working so must of broke wiring in the cable What...
Type: Posts; User: iowabasser
Can you get a new transducer or get it repaired? When deployed the transducer cable broke wire ties and got caught. The lowrance Elite FC 9 quit working so must of broke wiring in the cable What...
Thanks alot for the info haven't tried it yet but I am further ahead than before thanks again
iowabasser
I installed a ghost trolling motor over this winter went out to calibrate. Got on the water and started the calibration but it wouldn't lock in the deployed position. Has anyone had this problem....
Thanks I will check those but it will a couple days before I can
Iowabasser
Alarm went off the other day 3 short beeps pause then again. Water pump inpeller replaced in May plus thermostats. Any ideas thanks for any help will be appreciated
Iowabasser
no I haven't
just changed the water pump when problems started plus fuel water separater changing thermostats now
it goes up to about 20 then goes to about 5 and the alarm goes off
I have a 01 mercury efi sn OT281679 the problem is I think is the poppit valve. Have 10-12 water at idle then goes up with rpm and then starts lowering pressure and warning horn goes off. Can you...
can't believe if it such a crappy place he lets his wife work there
I have a 2001 296 Charger and got a new graph with sidescan, where would you suggest to mount the new puck. On the transom or on the step. Thanks for any help you can give me
My bleeder valves have had the corners rounded off where could I get some?
I bent the shaft of my motor. I had the armature replaced plus trolling motor rebuild kit that had brushes and holders. The problem is now it makes more noise and there isn't any endplay. Any...
Was thinking about adding a power-pole onto my 2001 296TF with 10" TH highjacker jackplate they don't list an adapter plate for it. So I thought I would check here on it.
Any help would be...
Was wondering if you still have the rubber rod tie down for the front deck.
Thanks
iowabasser
Going to change my bearings and seals on my Charger 2001 EZ Loader dual axle trailer for my 296. Would you happen to know the part numbers for seals and bearings. Thanks for any help.
iowabasser
How to replace shear pin after broken and shaft turns with nut:crying:
will check tomorrow
I was wondering what the length of the livewell cables are on a 2001 296TF. Am having trouble getting to the right postion for operation since there is no adjustment in them I thought that I would...
no it is not
I have a 2001 ez load tandume trailer. Last year the right rear tire was closer to the top than the other thinking that the spring was bad I had the two rear springs replaced. It didn't seem to...
Menard's have them in the electrical to replace knockout in electrical boxes less than a buck a piece.
I always use a drop of dish soap on the inside and outside, rub with water running haven't had a problem yet
What brand of gel coat do you use on your boats? I have a few light scratches that I would like to fix this winter. It is a 2001 model. Thanks for your help...
There was something on it a while ago you are going to be standing outside with a tennis ball along time it doesn't work