Search:

I currently run a 625 with a 250 sho and average 76 mph with a 27 bravo. Anyone have any results with a fury 4 blade?

I have a 625 with a 250 sho 27 pitch bravo fs 4 blade. Dual power poles 10 inch hydro plate, 5 graphs on my boat. My boat tops with just me at 76.4 so far 6100 rpm 3 inches up on bobs gauge and 1...

Well guys update on my crestliner pt20, the repair they added to the keel has started to crack where the two pieces were welded to the other piece, there are multiple cracked welds under the lids...

I was out on conroe and put a pretty good beating on the boat, not a single drop of water came out when I pulled the plug, I'll be going to Sam Rayburn for 5 days next week due to a tournament....

Just got the boat back with the new bracing welded on. going to the lake to test it out tomorrow. here's some pictures attached.

If you aren't scared to do it id recommend stop drilling the cracks a tiny bit past the end on each side with a 1/8 inch drill bit. Have had cracking issues with a tin boat to and it seems to keep...

Did you lose any performance after they put a piece on the keel? After crestliner put wedges on my hull it has to be trimmed all the way up to get any lift over 4500 rpm and it tops out at about 50...

The lund boats cost more but the riveted construction allows some flex and it cuts down on stress cracks like with welded boats, im not sure if lund has went to all aluminum construction like...

At this point I plan to get through my april and may tournament if it even lasts that long and file in small claims, hopefully they'll buy it out, even if they replace the hull crestliner has left a...

Keith Poche has left sponsorship with triton and bought a gator trax boat, other than the few promotional videos they have I haven't seen a triton aluminum on the water except the smaller models.

This is what the orginal crack looked like before it was repaired the first 2 times.

So update, the dealer allowed me to get in direct contact with the customer service rep. Apparently crestliner had a shipping issue that caused the part that was supposed to be sent 3 weeks ago to...

The dealer pushed to see if they would send an mx21 hull to move our motor and everything on to, due to the pt20 being discontinued and crestliner refused and said they would send a brace of...

I forgot to mention we stop drilled the crack before welding a 2nd time to see if it would help.

So bought a pt20 october 2019 and its had problems from the start, first porpoising but crestliner sent wedges and fixed it although it took 2 months for them to send them, than the transom cracked...

Thanks for the info! I'll have to try running it different heights between 3 to 4.5 inches up and try that out next time I get out to the lake and see how it works out.

Yes it's the mercury 4 stroke Pro Xs, It's a 2019 crestliner. The dealer installed 2 wedges sent over from crestliner and it took care of the porpoising problem awhile back. However I have gotten...

I am running a crestliner pt20 with a merc 200 pro xs v8 and a nd a tempest plus 19 pitch 2nd mounting hole down with a 6 inch hydraulic jack plate, with 2 people a cooler and light tackle I can only...

I am running a crestliner pt20 with a merc 200 pro xs v8 and a nd a tempest plus 19 pitch 2nd mounting hole down with a 6 inch hydraulic jack plate, with 2 people a cooler and light tackle I can only...