Thanks!
Type: Posts; User: Nattyboh74
Thanks!
You're not the only one... I tried to go back to stock firmware and they couldnt take me back to day one FW... I think that they gave me as the only option was 1.86. They told me the original is not...
You can host them in Imgur but you shouldnt need to start a new post... You should be able to add them here no problem...
Its actually non-conductive, thus why it insulates. The pin's connection is so tight that it bypasses the grease, so I was told. Basically the interference fit of the pins is tight enough to bypass...
Thanks! I'll add a slight amount of dielectric grease
You don't think it's going to degrade the sonar coming back into the unit any, right? As in weaken the signal etc
True. But an occasional clean with a good plastic safe electronic cleaner would take care of that
I'm most likely the only kayaker on here, but with that being said , my Helix gets wet. On my old lowrance there were waterproof connections on the plugs, the Helix doesn't seem to have anything...
Email sent
Yes he's the most qualified here to make decisions and review on such units
Would be a great asset to us here
Wayne these are my questions, hopefully its not too much nor a bother. As you all know we appreciate all you do for us here...
First off I have it set to custom and not angler, so its unlocked in...
I have a 1.86v Helix 9, and I too noticed the contrast doesn't work today as well... This is in DI mode too.
So I have a HELIX SI+ G3N unit that I just cannot get dialed in... When I first bought it, I had great images... I updated it and made it WORSE, very dark, unit would freeze, restart etc.. I spoke...
Any idea on what model we would use for the Helix 9 SI?
I updated and it was worse. I'm not going to update
Didn't help
I have a Helix 9 g3n and I have a double bottom in both 2d and DI+. If the water is 3' deep say, I noticed it'll show another bottom at 10' or so... Any idea? I think I asked this a while back, but...
I doubt this as HB gives specs from what, 10.8 to 20v? IMO if you're within those ranges it should be ZERO issues
Keep in mind that the smaller Helix 9 did get a screen resolution upgrade this year along with a redesigned bezel and not one that is shared with the 10"
They do, just chat with them And you'll get a link to the file or they'll email it to you
Ive had similar issues with my G3N Helix 9. I went out say Saturday, used it as it came from the factory, worked great. Updated and went out sunday same water etc, looked terrible...
Is this update going to come out for the g3n Helix 9s
What are you seeing, the dark images/grainy images?
I had three same issue , the dark SI / DI readings plus they weren't as sharp. They sent me the file without any problem
so you're saying that the connector at the back of the unit that houses the cables was causing your cables to not seat correctly? As far as interference, is it an electrical one? If so, use a ferrite...