Search:

Just curious... when does your warranty run out?

The adhesive backed rubber strips have have worn off the aluminum hold downs and know longer are isolating themselves from the tank. Concerned this will rub a hole in the tank. Any thoughts what...

Thanks for the response Tall 1.

Thanks Joe for the feedback. I believe any strap that can be secured would work. The picture that I saw had the strap pulling down the bow eye to the frame. I may be wrong but it seems like it is...

Thanks all for the feedback. I was able to move the stand forward to the point where the entire transom sets on the bunks. I could have moved it more however this was have move put the U-bolts just...

Is anyone using a boat buckle to tie down the bow to the trailer? I saw this on the web...

I was successful! I did notice the u-bolts were not as tight as I expected. Thanks Bill

Thanks Bill for the response. Going to try it this morning as soon as it warms up a bit...

Can the winch stand be relocated with the boat on the trailer?

Can the winch stand be moved towards the hitch without removing the boat?

While installing the new F2 winch I noticed the winch was touching the keel of the boat during installation. Since having the boat I noticed after loading I would have about 2" overhanging the bunks....

Now on to the next problem...

:embarassed: I'm a bit embarrassed... The problem was there was no problem... shzz :embarassed:

For those that have replaced their Ranger Trail jack with a Fulton XLT. Did you have any interference with the original winch handle? Thanks

Has anyone mounted their group 31 trolling motor batteries using something other than the Bass Cat trays? I like the trays however I'm just plum out of money to drop $120.

Look at Post #5 above...

Thank you Surferboy for the feedback. I like your logic of locating the actuator by the main circuit breaker.

Considering installing a Flow-Rite remote drain on my RT188. I have some questions regarding installation: Does the new plug fit into the exiting opening? Going to drill a hole as Bob suggested...

No sir raising/lowering is not an issue. It's getting the trailer to roll in a different direction without kicking the wheel. It's the original jack that came on the 2016 RT188's

My existing jack requires the wheel to be kicked to move in a different direction. I am under the impression a pivoting wheel that has a bearing should make the trailer easier to change direction.

Thanks all for your feedback. I went with with Bassakwards BBG suggestion. Compared to others it's a good deal for the MK 330D.

Thanks for the response. who is the board sponsor please?

Thank you for the response. I am interested in the Sportsman SS3 please.

Which of our preferred vendors sells Dual Pro chargers please?

For those who have replaced their battery charger what criteria did you use to select the charger you purchased? I have a 3 bank Dual Pro RS3 that two of the banks stopped working. I am looking at...