Thanks for the help guys i had gotten the helix 7 cable from the factory. New adapter cable fixed my problem.
Type: Posts; User: MARKTN
Thanks for the help guys i had gotten the helix 7 cable from the factory. New adapter cable fixed my problem.
the two different cables have diff number of pins right? Mine has the 7 pin.
I will look into adadpter cable it came pre rigged on a new boat.
Thanks for the ideas
I have another helix at the console that is only connected by eithernet cable.
Pretty sure it was on mega and now that i think of it i did flip through frequencies and it didnt help. Any other ideas?
No sir i did not change the frequencies for some reason i didnt think to. Will try and update thanks. What frequence do you recommend?
Also i have the Built In Transducer selected i have tried both ways and it is the same with either.
Forgot to mention the 2D sonar seems to work fine as does temp.
Brand new trolling motor and graph. I can only get the down imaging to show on the screen if i do contrast and sensitivity completely opposite of each other ( ex contrast on 1 and sensitivity on 20)...
I have a 2015 90hp 4stroke yamaha (grey motor not sho) that will not rev past 3500 rpm. The motor runs flawless but just doesnt go past 3500 rpm. It does not sound like it hits a a rev limiter, it...
Could be fuel pressure regulator i am about to replace on my motor i will update. When i pinch the return line on the fuel pressure regulator it seems to clear everything up.
Thanks parts should be in today. I had a feeling it should leak at all. I really hope this fixes the problem been chasing the problem for a while now. Thanks for the reply.
Its a johnson evinrude , thanks for the heads up. I may have found the problem. I had the hood off and was squeezing the primer bulb and the line that goes from water seperator to low pressure fuel...
Thanks for the reply just needed a little confidence before i tore into the tank.
Vapor lock how would you fix that? Is that on the boat side or the motor side?
My motor also has a rough idle until you give it a little gas and then it clears right up but the primer bulb stays soft. Primer bulb will hold pressure as long as the motor isnt started. the high...
i have a 2003 225 as well mine was doing the same thing everynow and then. Be running down the lake and it would just fall on its face and then pick back up. It was my high pressure fuel pump. ...
I dont know if your livewells are set up the same as my 96 201 pro but this old post helped me understand the steps and all that is involved to get them to run. It is kinda a pain until you get used...
I have a 96 stratos 201 pro xl with a honda 225 on it. Primer bulb will not stay tight after motor runs for a little while. Primer bulb will stay tight if you pump it up and dont start the motor, ...
I have a 2003 honda bf 225 that had a seal go bad on the trim cap. I got a lot of water in my fluid and am trying to drain all the fluid without removing the whole assembly. Currently i have the...
i think the alternator is working properly bc after a run voltage goes up. Probably time to change the battery anyway. What do yall recomend for a 2003 honda bf 225 cranking battery.
New high pressure fuel pump installed. New fuel lines all the way from tank with new primer bulb. New anti siphon valves. Still running rough at idle. I noticed my depth finder said 11.5V...
Does it matter what kind of fuel line you use as long as its ethanol safe? Can you get it at the local parts house? Or does it need to be marine.
yeah i took my boat apart last night. It is a 96 stratos 201 pro with original fuel lines. Decided to go ahead and replace all the fuel lines while im in there and the anti siphon valves.
Bassnailer, Where is the anti siphon valve located. Is the the elbow that the fuel line goes into on the top of the tank?