Copy that. I guess my thinking was if the tracker valve was leaking by the fuel pump would continue to go on/off as fuel pressure was slowly bled down (like a car) and filling the air side with fuel....
Type: Posts; User: bryceban
Copy that. I guess my thinking was if the tracker valve was leaking by the fuel pump would continue to go on/off as fuel pressure was slowly bled down (like a car) and filling the air side with fuel....
2000 Optimax 200hp SN: 0T162266
This is a new to me motor I got and it's idling a little rough. It is doing the high rev at startup, rough idle, had fuel come out the port side rail shrader valve...
I have no idea on the motor but I'm glad you mentioned that. I will keep that in mind and research how to tell the difference. He needs to take it out and run it, it has sat for last 1-1.5 years....
Man, maybe I should snag my neighbors 07 Skeeter ZX225 with Yamaha 225 HPDI with probably less than 200-300 hours and 36v Fortress TM for $15K. It's mint and been kept in climate controlled shop its...
Holy smokes! That's an insane price. I know prices are whack around the country but I didn't know they were that bad.
Mine were stuck when I bought my Corral last year and had to use a high lift jack and lifting strap to remove. I found a round emory type flap disc sanding wheel that fit on a drill and worked them...
Larry, could you please send me the info via email? Thank you!
UPDATE:
So after pulling lower unit to recheck water pump and get a look up in the midsection to look for any blockages and pulling all water hoses to check for blockages, etc. I pulled the...
Thanks billybas for that. I may holler at you. It's crazy to think that flushing sand would be such a pain. Seems it would flush easy
TX 201 I don't have a temp gauge, wish I did and would love to...
Also, compression tested good at Merc dealer. I could do a leak down test before getting too deep into it.
Motor runs great until I back off due to alarm. Pressure is pegged at 35+psi at 1,500 rpm and above. 15ish psi at idle. I doubt gauge is 100% accurate but that's not the issue. I guess I could have...
1998 Mercury 200 HP EFI SN #OG606131
Hello, I’m having an overheat alarm at ¾-WOT. A steady BEEP. Motor has a new water impeller and housing aswell as new fuel pump installed by Mercury dealer...
Howdy, I'm looking for some opinions and advice on a problem I had today taking my new to me 97 Viper Coral 201 F&S out on it's maiden voyage. Motor is a 98 Mercury 200HP EFI SN: 0G606131
A little...
My apologies, it says "Mercury" and "stock" which mine is and no mention of HP rating in sub-forum title and I don't consider it "high performance".
Mods please delete
Howdy, I'm looking for some opinions and advice on a problem I had today taking my new to me 97 Viper Coral 201 F&S out on it's maiden voyage. Motor is a 98 Mercury 200HP EFI
A little backstory: ...
I just bought a 97 Coral F&S and had the same problem on rear seat. I put a choker around post and used a high lift jack just like removing a fence post. I then used an emory cloth sanding flap...
Howdy, new here and would like some input please. I'm going Thursday to look at a 2006 192 superpro with an 06 merc 200 Optimax and was wondering about a rough estimate of top speed in stock form...