0T759055
friend may need to replace oil tank as he is getting a constant warning beep when key is engaged. This happens in the driveway with key on but without attempting to start. When in...
Type: Posts; User: getreelgofish
0T759055
friend may need to replace oil tank as he is getting a constant warning beep when key is engaged. This happens in the driveway with key on but without attempting to start. When in...
409758409759409760409761409762409763409765
1998 motor with 850 hours. I believe it was the original compressor. I have a pic of the number and will check.
1998 Optimax 225. 0G741039
When I came off plane on last trip out I noticed a different sound on the motor. First thought was either lower unit or compressor. Changed gear oil and appeared...
https://youtu.be/SIuqFc8GheQ
1998 Optimax DFI 225. 0G741039
Came off plane and noticed a different sound from motor. Searched BBC and youtube videos for compressor sounds. Mine doesn’t seem right, or I am on wrong...
Thank you.
Removed these from boat that was purchased by my brother. What would the reasonable value be to sell, provided they have any value.
Posted in Restoration but haven't received any advice just yet so I thought I would ask here as well. Can Weldwood CC be applied to both carpet and foam pad for installation in an aluminum boat? ...
Can this be used for carpet AND foam pad installation on aluminum deck?
Read up on quite a few carpet / glue threads. I have a 20' Crestliner - never had carpet. Picked up leftover carpet and foam pad for free from a BBC member. I believe he indicated it was from...
Any and all help appreciated.
Friends motor, idles fine but slow to get to plane. No owner/mechanical changes since fall use. I recommended spark plugs, fuel filter, fuel line and bulb. Run on remote tank with fresh gas.
...
Check each plug boot and wire CLOSELY! Had same symptoms, took a month to figure out but had tiny cut in one and pin hole in another. This board helped greatly. Replaced wire/boot set and magic...
Thank you Don. I will get them ordered.
I was having a "bogging" issue at take off and could not get above 5000 rpms the last time out. Last summer it bogged a few times and at WOT hesitated...
http://www.bbcboards.net/attachment.php?attachmentid=311598&stc=1http://www.bbcboards.net/attachment.php?attachmentid=311599&stc=1If the wire/plug item can be replaced, what would be the part number?
May have an issue with a coil or plug wire. I am not sure if the coil and plug wire are one unit on this model or if I can pull and replace just the wire and boot.
thank you .
1998 Optimax OG741039
in the middle of the pulse pump rebuild.....parts directions show installing plastic check valve (round like a washer) but no mention of reusing rubber check valve.
My book...
After further inspection - been away from boat this week- it is better than thought. Will need to just rework prop, thankful for alum props. Thank you for the service advice.
Bent prop shaft on yamaha F90. May need new LU but looking for someone local to tear down to inspect. Best case would be new prop shaft and possibly gears, worst case new LU. Any local me...
Thanks all. You provided what I was interested in hearing
Looking to move to dobyns rods. My all-time / old time stick is a Team Daiwa Light&Tough.....flippin/pitching 7'6 for weights 1/4 - 1 and 1/2. I have three still but want to test the waters with...
Looking to replace jackate to motor bolts for my 225 opti. Coarse or fine thread?
Shout out to booter for his generous giveaway. Nice meeting you.
Thanks for the clarification Don. Happy New Year.
0G741039 1998 225 Optimax
In September you messaged me regarding the location of my compressor water strainer.
....strainer screws straight down into the top of the block (between the air...