Thanks for your help. Used a heat gun to soften about 2-3” at a time. Put bottom lip in place, heated the insert and pushed the top lip into place with a large flat blade screwdriver.
Type: Posts; User: Jims Ranger
Thanks for your help. Used a heat gun to soften about 2-3” at a time. Put bottom lip in place, heated the insert and pushed the top lip into place with a large flat blade screwdriver.
Caught the side rail insert on the lift. Pulled about 18” out. How do I get it back into the rail? Thanks
Prayers for both of you. HE is the healer!
Need more help!
Replaced both adapters and ethernet cable with new.
Ran new dedicated 10 gauge from battery to front 10"
Checked out voltage on 10", getting 12+ v.
Plugged in 12" at console,...
Thanks Mark, for helping the ones that are smart, and putting up with the ones that are smart a**es
Have been using a double uni, tried the FG but was too much work, especially on the water!
Want to try this one Gman showed - one Uni, less stress on the fluoro, easier to tie.
Heard Joe Biden was the instigator :wink:
Thanks!
What line size is recommended between battery and units?
Good questions, will check them out.
I do have power running directly from the cranking battery to each of the units.
Wayne, any recommendations about where to look next?
I'm stuck with no front HB.
Thanks,
Jim
MB,
these are both Gen 1.
Will try longer between turning 12 and 10 on.
Thanks
Great idea!
Continuing frustration!
Had turned CHIRP off on the 12"
Replaced one adapter which cleared the problem and took it on the water for about 30 minutes, worked perfectly
Next morning, old problem was...
Followed your advice (both of you) and turned off Chirp on the 12, disconnected and reconnected/snugged adapters and cable, and got a minute or less of sonar show up on the 10, then the Lost Source...
Thanks for the recommendations! Will give them a try
Helix 12 at Console, Helix 10 at bow.
Single set of transducers (shoot through 2D and DI/SI) connected to Helix 12.
Cable connection from Helix 12 to Helix 10.
Settings on 10 to recognize Helix...
Thank you, great help!
Enjoy Thanksgiving, so much to be thankful for.
I have been a bank beater for years and am just starting to learn to use lake mapping to identify offshore spots.
I have a 2019 LakeMaster SD Card, but haven't used it in my Helix 12 yet.
I want to...
Did the same. Really like Lews Tournament Pro!
Thanks
Do you expect upgrade bearings (Boca, Spool Speed, others) to be replaced at some point?
How long would you expect between replacements?
Thanks for the info!
I upgraded to Helix 12 and want to buy a new Lakemaster card.
What's your preference for Southeast? Lakemaster 5.0 or Lakemaster Plus 3.0.
Fish Lake Guntersville.
Thanks!
I'm replacing an older Plus. What added features are in V3.0 Plus vs V5.0? Thanks