Last year with very little run time on them, I am heading up to lake where boat is this weekend and I will pick up some plugs to rule that out. Sometimes the simple stuff gets us!
Type: Posts; User: wed68
Last year with very little run time on them, I am heading up to lake where boat is this weekend and I will pick up some plugs to rule that out. Sometimes the simple stuff gets us!
I have a 2 stroke 150 VMAX with Carbs, on acceleration from a stop I get a stutter until boat is on plane. Top end engine runs great and smooth, stutter is like a miss maybe 4 or 5 before I get on...
What’s the boat look like? To me you gotta be careful and not get to upside down on value, mind you anything you do is gonna put you somewhat upside down. If boat is clean and lower and mid are...
Got a small reprieve from work and jumped on boat troubleshooting, remember boat set up for year! Found rat damage under console! Splice a few wires back together and dropped it in water. Ran...
I can not work on it for a week due to work starting tomorrow ……… stand by I will update soon
It’s very random ……. Could it all be electrical?
Correct
Low pressure drops from 26 to 18 quickly then very slowly lowers
high pressure side drops from 108 to 15 quickly then holds steady
The fuel low pressure side is the valve on the VST?
Ran on remote fuel tank with same symptoms
When engine dies fuel pressure drops sharply to 15 psi and holds steady, air pressure drops slowly to 70 psi then very slowly continues to fall
When...
Will do Don thank you
Sorry my order was wrong
engine sat unused for years, rebuilt pulse pump, cleaned VST and replaced lines before trying to start
I also did the oil pump prime sequence before initial start up
Thanks Joe …… I will try that soon
Does Tach have setting on back for different engines?
S/N 1B757070
Fuel/Air pressure at idle 108/95
Pulse pump is drawing fuel fine from tank
Fuel filter is new and clean
Fuel lines new from tank to pulse pump as per recommendation of this...
Thanks
Yes sir the washer is there, I checked parts diagram. It appears to be correct bolt? But it’s kinda odd it’s threaded the entire length is that normal?
I checked out bushing and it does not appear to be worn terribly, what does appear to be happening is the bolt is loosening while running. Any issues with me putting a little locktite on bolt...
Thank you both for your replys, I will check for worn bushing. I do understand that tightening this bolt some is NOT how to reach WOT and I have read Hotfoot setup however I still could not reach...
2006 Merc 250XS 1E001564
As I was making sure my throttle plate was opening fully I noticed throttle cam on side of throttle body was loose, the only way I could get a fully open plate was to...
Thank You Don!
432848
left side 020-4P
2 03A
right side 021-4S
2 03B
Thank You for the help
432770432767432768432769
Sorry for the smartcraft question ...... I just found the sticky on top of forum!
2006 Mercury 250XS serial 1E001564
On a BassCat Puma with Tach and Speedo gauges that have smart craft LCD screens on bottom, they are both hard to read the screen due to a blackening spot center...