The vro was capped off. The mechanic rebuilt the carbs . I may need to check the floats and recirculation valves.
Type: Posts; User: ga284
The vro was capped off. The mechanic rebuilt the carbs . I may need to check the floats and recirculation valves.
Hey guys, looking for suggestions . Had this motor rebuilt earlier this year, bypassed VRO. The motor loads up bad while idling. The boat runs good other than that. Before having rebuilt while still...
Thanks for the info.
Yes it has a cable. I may just take it to a local shop. My fear is if I buy one online that is flashed everything may not be right and I would still end up going to a shop.
Thanks Leon, they did not try to clear the code. I was worried that the truck may go into a no start condition. What is your opinion about buying one that has already been flashed ? I have found...
They did not tell me what the code was.
I have an 02 Silverado with 208,000 miles. Check engine light came on. Went to Autozone and got them to check the code. The code said repair ECM. The truck runs and drives fine. Anyone had this sort...
Thanks guys
Anyone fished there lately ? Thinking of going this weekend. Wondered how the was.
Thanks
I have found the aluminum flange and installation tool online. Not sure whether to go that way or get a flow rite plug. Anyone here switch to the flow rite and how do you like it ?
I have a 1991 ranger 370. It has started leaking around the drain plug flange. The adhesive or sealer has broken loose from the hull. When you tighten the plug the whole flange turns. It has the...
Is this transducer compatible with the Helix 9 SI for 2d sonar readings ? XNT 9 DI T
Just purchased a new Helix 9 si . I am going to upgrade the transducer to the HD transducer. Can I go ahead and operate the unit with a regular di 2d sonar transducer until I get the upgrade ?
...
I have a 1990 GT 150 it done the same thing. I wound up replacing the stator and power pack that fixed mine.
Which ramps are the are the best to use with the low water conditions ?
How is the fishing at Weiss now ? I really struggled there this summer. Haven't been in a few months.
Thanks for the info. guys. Don't worry about it Championman we all have days like that.
Thanks
Getting ready to rebuild carbs. How many kits are needed 3 or 6 ?
Thanks
When my son drives the boat on the trailer it always loads to far to the passenger side. I always have to get my him to move over to the passenger seat while I back in a little deeper to get the boat...
Anyone ever used Roberts 6040 adhesive for boat carpet ?
Ok thanks
Thanks gearcaseman I've been setting around all evening wondering how I was going to get it out.
The lube looked good it had a little water in it. I was changing the seals because they had started leaking after my last trip to the lake. Everything look good except that piece of broken snap ring....
I was replacing the prop shaft seals today. When I pulled the bearing carrier I found the end broken off one of the retaining rings in the foot. It is the one that is closer to the boat. So it is...