Mercury 200 1994....here is the problem....starts and idles goog....on plane rpm guage works for a short time then go to 0 for a couple minutes and then back to showing rpm again....stator or trigger...
Type: Posts; User: trex
Mercury 200 1994....here is the problem....starts and idles goog....on plane rpm guage works for a short time then go to 0 for a couple minutes and then back to showing rpm again....stator or trigger...
what should be motor height on an 18 ft, champion witg a 2.5 mercury 200 and a 5 in. jack plate? thanks
Whats the difference between a Hopkins prop and an et prop???
Reason being It has a 10 inch on it and I have a 6 inch hydro with a 225 pro max...wasn't wanting to have to buy another plate
What is the ideal set back with a hydro jack plate....Is 16inches too much???
Any shadow boat owners out there???
150xr6...ot971185....replaced exhaust tuner...now water coming out of yoke bolt heads...re- pulled power head to check gaskets and motor mount seals...all good...what could be the problem???
so is a ranger, but I ran one for years
anybody run a surface prop high on a gambler???
Where on the block can I find serial # for a xr6??/
Will core 50MG7 handles work on scorpion 1000mg reels????
Will core50MG7 handles work on CH50MG scoripion 1000 reels????
How do I link 2 93sv units together....Is there a schematic
All three of those guys are top notch...But I would also look for a pro-max motor...
Water pressure is fine...about 12lb. at wot...
94 225 pro max power head #OD936132 bolted to a 96 super mag mid...burning hubs up...If I lower my timing will that cool my exhaust any??? thanks
I have a "g" also and run a trophy 4 blade...comes out fine and runs well with tournament load...I have ran that same case on my set up and cant tell much difference...
I see you're running a "g"...have you ran a chopper on it???
I have a case just like it...I did come on the mod v-ps...I ran mine on a ranger for years with a chopper prop.....was never beaten out of the hole...heavy duty gears and prop shaft...
Jay. I have the temp. gun. Can you explain in more detail how to preform this test and what #'s should I be looking for???thanks...
10-4 on the restriction...Got one more tournament to fish and after I will pull the power head...Thanks guys
So I can pull the inner liner and not relieve the exhaust and you think it will cool my exhaust???
Boat runs great and haven't had any problems with the solid hub..Just have a couple props I can't run...yeah, I don't want to pull the liner...
Wow! Either of those suggestions is a lot of work...
Been chasing this problem for some time now...I burn up stock hubs in my props. Had to go to solid hi-po hub....water pressure is fine...motor runs great...225 super mag mariner....stock 2 piece...