I am looking to buy a new Hydraulic Jackplate 6" or 8". Boat is a 99 Triton TR20 with a Mariner 2.5L EFI running a 25 Tempest plus. I am wondering how much setback is optimum for this boat?
Thanks
Type: Posts; User: 99tritonrob
I am looking to buy a new Hydraulic Jackplate 6" or 8". Boat is a 99 Triton TR20 with a Mariner 2.5L EFI running a 25 Tempest plus. I am wondering how much setback is optimum for this boat?
Thanks
Price on a 6" and 8" please. Thanks
Can I get a price on an 8 inch with level and guage to Ontario Canada? Thanks
99 Triton TR20 200 EFI with two people in boat light tackle, empty livewells, half tank of gas top speed 62mph. Motor is at 3" below pad, 8" manual plate and 25 tempest plus prop turning 6000rpm....
Thanks for all the advice on new panels.
Does anyone know where I could get custom panels made for my old Tr20 instead of those plastic woodgrain ones.
Thanks for the help and I am exchanging the transducer to the hdsi one. I only have one unit for now.
I plan on installing the si transducer on the trolling motor only and just use the 2d sonar for driving around for now.
Thanks Wayne I will now order the shoot thru hull transducer and try to find the best spot. There was an old Lowrance puck there but it lost readings all the time so I removed it. I just purchased...
Is it better to use the puck shoot thrust hull transducer or the transom skimmer for high speed readings on a 1999 triton tr20? Also where would be the best place to install the transducers?
Thanks anyways.
If u still have one of those panels left I will take one for my 99 tr20. Thanks
Does it matter if u use the third hole or fourth to attach the motor to the jackplate? I need to use the fourth hole so that the steering cylinder nipple does not contact the top of the jackplate...
Does it matter if you mount the motor on the third hole or fourth hole. If mounted on the third hole when I trim up the steering cylinder nipple will contact the top of the jackplate. Setup is 99...
Thanks for all the help Don!
Thanks for the help so far Don. I verified at the engine that the throttle lever would not go to WOT because it was being restricted by the WOT stop position. I adjusted this so now it does. I...
Don
It is operated by the hotfoot throttle. At the engine I pushed the butterfly controler and the butterflies will open no problem to the 90* mark. I also noticed that when I first actuate the...
How does one go about adjusting the WOT position to ensure both butterlfies open to the 90 degree position?
Thanks
98 200 Mariner EFI. When you depress the hotfoot throttle to the floor at the engine the butterflies only open to about the 80 degree mark. If I take my hand and push on the actuator inside the...
I have a 99 TR20 that I was running with a 25P Trophy Plus, but decided to try the 25P Tempest Plus this season. I was running the other prop at 3.0" below pad. What would be a good setup for the...
The jerky feeling is the tongue is sliding back and forth, in my opinion to freely especially when travelling slow on bumby roads.
I pull a 20 foot triton boat with surge brakes, and my problem is that it is very jerky when being pulled. Is there an adjustment so that there isn't so much free play with the tongue?
Thanks...