Looks a lot like the old Skeeter. It's my fishing boat here on Lake Fork. Anyone else out there got one?
Type: Posts; User: goinbassin
Looks a lot like the old Skeeter. It's my fishing boat here on Lake Fork. Anyone else out there got one?
That makes perfect sense Bobcoy, and I suspect that's the case. But what throws me is that I see no other lakes in Chart Select mention a county location.
Humminbird is advertising the Chart Select for Lake Fork as "Lake Fork in Hopkins County". Lake Fork is in Hopkins, Rains and Wood Counties. If I purchase this Chart Select will I just get the part...
Captains and E-7's don't dictate battle strategy, General's do. They're the leaders, and they're old farts.
Youngsters, led by old farts.
I was building a deck at the time and had some pieces of 5/4" x 6" pressure treated lumber left over, so... Used 2 pieces.
Butt seat and pedestal are gone. Center seat still available.
Just a heads up... I've posted seats off my RT188 for sale in the swap (miscellaneous) section. Ranger butt seat with power pedestal, and center fold down seat (between driver and passenger seats).
+2. Those little plastic retainers that hold the separate connections in the mount are pretty rinky dink and really don't hold up. Like others on here, I've replaced a few mounts because of them....
I like what you did there Bill. What did you use to keep the rope taut?
A few years ago, Scap, over at Transducer Shield and Saver, engineered a DI setup for a Skeeter I had with a CMC jplate. I still have that L plate and am hoping he can engineer another setup for me...
It was meant as a compliment. I've fished many tournaments where I fished "against" my partner. I rarely have had a problem sharing information or lures with the guy fishing with me. Doing anything...
Where did you see that?
Well done krr6581!
That came out good Coomdaddy.
Nice looking set-up Bill. I'm going with RAM mounts... hope I don't regret it.
Close enough Bill. Thanks.
Does anyone here happen to know what the transom degree of angle on the RT188 is?
Yup. Just wanted to make sure it wasn't a problem, as portrayed by some on the internet. Thanks for clarification.
My original question was answered... It is okay to use the Flo-Torq 3 on the Laser 2. Thanks to nova kaw for that. I'll install the FT 3 and keep the FT 2 as a spare. Thanks again.
You would think that as much as Mercury charges for a prop, the included "recommended" hub kit wouldn't be inferior. Very disappointing. Oddly enough, the cheaper aluminum prop that came with the...
The Flo-Torq 2 came in the box the Laser 2 came in (from Mercury). On that box it states " Mercury Flo-Torq hub kit 835257K1 is included with this propeller. If purchased for a non Mercury engine,...
If and when you go to stainless, buy one with the Flo-Torq system hub vs the fixed hub. This will greatly reduce your chances of harming your lower unit if you hit something with your prop. I...
X2!
Outstanding!