No washer that I recall. Slip the clip on the screwdriver so there is no interference with the hole or slot. If you're lucky you can get it on 1st try. I was able to get it started then pry it on...
Type: Posts; User: Tx Champ
No washer that I recall. Slip the clip on the screwdriver so there is no interference with the hole or slot. If you're lucky you can get it on 1st try. I was able to get it started then pry it on...
Custom Mold & Tint was the OEM supplier. You might have better luck with them.
Welcome Kit! Got an email address?
Champ 2001, I went out and looked and I have the 22" set. You'll have to heat the tip up with a torch before you can bend it and use a benchvise.
546365 546366
Go to Harbor Freight and get the cheap set of long screwdrivers and bend the flat blade over about 1/4". You'll also need a little LED flashlight and a buddy to hold the pedestal.
I forget which...
Go back original. Nothing worse than lying your knee down on a big ass latch assembly, especially if it's a hot sunny day. Only modification I've seen is that some guys have done away with the...
TTT
As I think I mentioned before, I'm not familiar with the 3-way valve system. I can tell you that the pump switch in the Auto position is a fixed timer that is 1 minute on and 3 minutes off. In the...
Seen this? Replacing gas cly in snap lock pedestals I've replaced 2 so far.
There's 1 listed Boats4Sale5 (bassboatcentral.com)
Paxlovid is for Covid. Hope you get to feeling better soon Rodney.
Congrats on the 198 ... you'll love it! Quagga mussels huh? That's a new one on me. Texas is dealing with Zebra Mussels.
6" Rapid Jack was the jack plate option from the factory. It's the best mechanical plate there is. If they still offer the Champion cut, you want that.
My 210 isn't as fast to get on plane as my 201 was even with 50 more hp. My opinion is that the beam forward hulls, 198, 200, 206 & 210 have more hull in the water than the 86" and early 90" hulls. ...
Your 204 may be a little wider up there than the 201 accounting for the pedal location. The 204 was one of the first 90" hulls, the 201, 86".
Mark Talbert is who you want to talk to at C&O. Carol "The Parts Mom" has retired.
To All You New Guys
TTT
They are not needed
From what I've read, Mercury 4 stroke likes less pitch than the comparable 2 stroke and the SHO can run the same prop.
:thumb up2: :thumb up2: :laugh:
Well worth the money IMHO. Just need to use the recommended o-ring lube. I've never had an issue. And it's a whole lot easier on my knees ... :laugh:
But back to your original question, yes the...
Aurora Canvas was he OEM provider in the latter days. Aurora Canvas Custom Covers
You might reach out to Chris McLain at Classic Fiberglass in Sanger. He can probably give you a ballpark what it'll take to repair it. Don't guess it could be an insurance claim?
I like mine too, but it has 4 gauges besides the tach and speedo, so if I put anything bigger than a 9" graph in the center, I'll start covering them up.