2007 ZX190 150 carb 25m 8 dots 60-63 mph solo full load 20+ psi 5800rpm
I could go up a bit more but i fish a winding river and don't like the pressure dropping allot on turns.
Type: Posts; User: MUSKIE08
2007 ZX190 150 carb 25m 8 dots 60-63 mph solo full load 20+ psi 5800rpm
I could go up a bit more but i fish a winding river and don't like the pressure dropping allot on turns.
Is that a power pole bracket?
Came with longer bolts and washers for mounting to jack plate and i think it came with the bolts washers and nuts to mount the talon to it. All nylon lock nuts and nothing has come loose on mine. Not...
Bracket j6p 6 inch short
I really tested mine this weekend in a tourny. the River i fish was high with allot of current and we had 20-25mph winds with 40 mph gusts all day and the bracket worked perfect and the talon held...
How much for just the air duct molding piece (is it a 150 vmax carb?)
bump Ready to order new but just checking again price has gone up to 306.00
I Have a 2007 skeeter zx190 and a the j6p bracket worked fine for me i have about 4-5 in of clearance from my motor and 1 1/2in from the sponson. My bracket is only the short one but there is no...
They want 289
I need a new air ram inlet for my cowling. I took it off to have it repainted and I slid it back on cuz it was supposed to rain and forgot it was unbolted and it blew off and is gone. Dealer wants...
I have not been able to try it yet the rivers and lakes i have been on are flooded and are at no wake. Its perfect for playing with the Scan but i takes forever to go anywhere especially going...
Mine is working great where i moved it to now. where you have it did not work on mine must be little different between model/ year cuz looking from the side the back half of the ducer was blocked by...
I tried mine back there around hole your strap is in but mine is a 2007 zx190 and the sides of the boat come back past that point so the front half of the ducer is interfered with. i made a bracket...
Does anyone have a pic of were they mounted the lss on a zx boat. I mounted it on the jackplate using the hole on the bottom and it is interfering with the boat. just not sure where to put it for...
My panel would do the same thing. after skeeter replaced my panel three times i diagnosed it myself i found the relay for the panel is in the fuse box on the floor and my had got wet and corroded the...
I have a 2007 zx190 w 150 carb i wanted the 175 but cost and reliability put me in the carb. the 150 carb motor has been around forever. I even heard the carb is faster than the hpdi. i ran 59-61mph...
My back two hold fine i adjusted the front one so it fits very tight and it got better but still pops up in rough water i dont want to loose my cowl or get water in there. The seal pops up about 1/2...
My front cowl latch pops up in rough water i tried tightening it up but still pops up has anyone seen this before? 2006 150 vmax carb???
Yes i called a dealer and they said no more outlaw only sterling and 2100 or something like that. Too bad those are out of my price range I have to wait till my skeeter is payed off then maybe i can...
What does a new gambler outlaw cost they are sharp looking boats and do they fish as good as they look. The fit and finsh looks better than my skeeter. But i do love my bug also can you put a yamaha...
went out the other day and my power was back all day for the t/m and the starting battery which was an old t/m battery. performed great cranked the motor cold without hesitation and i ran everything...
I found out 29's will fit so got a set of them for the T/M and moved a old 27 to the starter. the interstate guy said it would be fine my motor only requires a 300-400 cca to turn it over and my old...
What is the biggest battery i can fit in my 2007 zx190 can i use interstate 29m's also i have extra good deep cycle battery, could i use this for my starting battery. my starting batt is starting to...
I only run 93 octane and never had a problem if anything it runs better than 87 i work for a auto shop and we see more bad gas coming from the lower grades than prem. i know when ht changes the heads...
Problem found the relay in the fuse box is not suppling power to the fuses when the panel is turned on good thing my dealer put in 3 panels all when a five dollar relay was to blame go Skeeter dealer...