Search:

Don, 250 4S serial # 2B644821, spark plug (NGK & Marcury) for this serial number please. Thanks

Thanks to all for responding about pulling the grandkids the the set up I have on the Nitro. I'll take all the options out there and figure a solution out. Hope summer gets here soon!

Thanks. Hope the 250 doesn't get hot.

Thanks for the info and I'll take into account.

Thanks Pat. I'll take a look at that option. With that set up, hooking it up to the tie down mounts on the jackplate the leads would have to run up and over the Talon bracket or under the Talon...

My grandkids are visiting next this summer and wanted to enjoy time on the lake if the fish aren't biting with them. I have the Mercury 250 hanging on a Bob's Machine jackplate along with twin MK 12'...

Thanks for info Don.

Don, if the cranking battery is a AGM and if it goes dead while out, can you use the perko switch to jump the cranking battery with a lithium ion trolling motor battery? Would this void the Mercury...

Gear ratio is 1.75 to 1 on my 250. That's why I asked the question on rpms.

The prop should spin to approimately 3800 rpm, what will the tachometer show to correlate to the prop rpms?

Nitro boats now offer Tracker Lithium WRM100-HP starting battery and 3 WRM80-HP Lithium Batteries (36 volt trolling motor system) in the 2022 Z21 boat options. These boats also allow for jumping...

I ran into this issue when the update came out 3-4 weeks ago also. HB is aware of it and hopefully fix on the next software update.

I have G2 Solix units (10 & 12). did the updates to 3.97, now have a pop up on the Solix units that shows right talon disconnected after both Talons deploy. Minn Kota CS tells me that they will...

Thanks Wayne and SLYdoggie for the info.

Wayne, if I don't install the updates on my Solix 10 & Solix 12 am I better off with the blue tooth as is?

Got $1000 gift card for use at Bass pro or Cableas and a $300 clothing gift card both from Nitro. Also got 2 hats from the dealer after asking for them. I did get another $250 BPS/Cableas gift card...

Sorry to hear about the job loss. I was laid off back in Aug 2019 due to budget issues in the state DOT. I'm fortunate that this was a job that I took after retiring from the state and have a...

Nice & enjoy. You'll be grinning each time you take her out.

I have a 2019 Z21 and recently added the Mega 360. I ran the wires (+,-, and drain) to the helm area (negative and positive blocks). I also added a lighted rocker switch to power the unit on the dash.

I agree, placed them on my 2019 Nitro Z21 trailer a few months ago. The original carpted bunks held a lot of sand and scratched the black hull up pretty bad. Had to have the hull redone and waxed to...