Search:

Thx

Hello,
I have a Helix 7 MSI GPS G3N and cannot find regular 2D on the main menu. I have down imaging and sidescan, but no 2D. Do I need to do a factory reset? I assume I'll lose all my waypoints....

I was told to run a LSS-2 with a shoot through puck on my Elite Ti.

The place that installed the graphs are saying I need a glassed in transducer for 2D while at speed. Not sure if the Elite Ti can do that?

So you need a Y cable then? I have the same issue as the OP.

Thanks I've watched just about every video plus Garmin and Hummingbird videos, if I had a Aluminum hull it would be done, but the hull shape is nothing like any video I've seen.

One would think the shop that installed this, that sells and equips the most expensive bass boats, would know where it should go. :(

Thanks for your help.

I have inserted some pics. The transducer was installed on the port side due to a step on the starboard side. I showed a straight edge aligned as close as possible to the transducer. The tape line...

I'm losing bottom around 12mph, what are the troubleshooting steps? I have a Elite TI 9.

Thanks,
Scott

It won't stretch, get silicone instead.

I wonder if clear vinyl will work also, it's a little cheaper
...

So the bearings were checked and they were fine, just needed the seals replaced. Had them replace the R rated tires for D rated, since the data plate mentioned that. They also upped my rear tire...

I don't know, I don't have a way to weigh it.

Also the data plate recommends ST175/80D13's and I have R13's

The tongue is to be at 18" +/- 1 1/2. It sits loaded at the bottom of the tongue at 16 1/2.

Hey Guys,
I have a Stratos 176XT with on a Stratos single a axle trailer. The trailer does a side to side wobble up to about 30mph. I have replaced all the wheels and tires and the wheels don't...

Thanks for the help guys.

Hey guys, I have a Stratos 176xt and it has a small Minn Kota 1 bank charger. I bought a new 2 bank, but it's a lot larger and I have no clue where to mount it. It won't fit where the old one was.

How do you measure to install a strut? I have a 12" strut for my center rod locker door, but don't know where they should go on the door.

I will take pics of mine and post. I have a 176XT also.

We blew a tire, (Thankfully I had a spare and the correct size lug wrench), got lost, fallen tree on road to the ramp, and the motor wouldn't start at the far end of the lake. The gear shifter wasn't...

Thx

Yes

Army 1983-2004
Cobra Mechanic - Finthen Germany, Ft Campbell, Ansbach Germany, Ft Campbell
Scout Pilot/Instructor - Hohenfels Germany, Ft Campbell, Ft Hood.

Hey Folks,
Have any of you 176XT owners installed a gas strut on the rod locker? How do you know what size to buy?

Thanks for the tips,