Stay to the south. A lot of lakes will still have a frozen lid on them that time of the year after a normal winter.
Type: Posts; User: MI_ProStar21XL
Stay to the south. A lot of lakes will still have a frozen lid on them that time of the year after a normal winter.
Agreed on the tough fishing. Should get hot this week though with warm stable weather in the forecast.
The MBN High School series was here this weekend. Not sure on day 2 weights but top weight...
Burt/Mullett were running low 60s mainly last week but the end of this week and weekend we had a huge cold front move in. Nights in the 30s and days in the low 50s so I'm sure the water temps dropped...
If I recall correctly there is a launch right in Elk Rapids. If you're in that area don't rule out Elk Lake and Torch Lake.
Hey guys, I've been searching through some older posts and seeing mixed thoughts on this issue. I have a 2002 225 and I've always ran QC12PEP plugs in it. I was told I could swap to QC10WEP plugs. I...
Had to replace my fuel rail a few years back for the same exact reason. It was spewing fuel all over. I used a small hose clamp to secure the Schrader valve to get me back to the dock. The fix on the...
Thanks Seahorse. In your first reply post, what part is pictured in picture 2? Also I'm guessing from picture 1 the gearcase would jabe to be unbolted and dropped to enlarge the existing water...
Hey guys, I've tried searching but couldn't come up with good detailed instructions or pics. I've heard there is a cooling mod that can be done on these motors to help keep the exhaust housing...
On the plus side we've had some wind to stir up the water so the swimmers itch seems to have improved.
I haven't been out in a bit due to a broken boat and hot hot Temps. Last time I was out surface temps were in the low 80s. I would expect it currently to be upper 70s to 80. Fishing wise I have zero...
Also just FYI the swimmers itch seems to be pretty bad in the lakes up here currently in some areas of the lakes.
Water temp yesterday was 70-75. Gonna be going up the next couple of weeks with 85+ degree temps forecasted long term. With the warm weather and increased boat traffic it'll push the fish deeper....
Water on Mullett warmed up a lot over the past few days. The shallows are in the mid 60s by the afternoon hours. This next week the lake will probably be at spawn peak.
I was out yesterday. Water temps were 58-62. Gonna be going up with warm stable weather. Lots of fish up but still not at peak yet.
I gotta say I somewhat agree with him. Last year up north the water warmed up extremely slow. I found fish spawing in cooler water than any other year before. Time of the year was the same as...
Fished Mullett yesterday. We had our best luck on the west side. Anything with a dark bottom whether it be the short sand grass/marl bottom or scattered logs. Caught all our fish on slow rolling...
Depends on where in MI you plan to go. State is still currently under a stay at home order until May 28 if our governor doesn't extend it again. Currently only the northern lower and UP regions have...
Water is still pretty chilly up here on Mullett. The fish should still be hanging mostly on the drop offs but with the warm sunny days should be pushing up on the flats and rocky areas during the day...
Been running mid to upper 40s here. Should start going up this week with warmer temps in the forecast.
I just got a 36v 52" non link US 2 Ultrex from MyGreenOutdoors here on the forum. After shopping around and contacting all the board sponsors that advertise here they had the best deal on the motor I...
Anyone successfully mount an Echomap SV transducer on an Ultrex with US2? If so any recommendations on how to mount it? Pics? TIA.
Anyone successfully mount an Echomap SV transducer on an Ultrex with US2? If so any recommendations on how to mount it? Pics? TIA.
Haven't been out yet but we've had some cold days and nights the past couple of weeks. Looking ahead the temps get back to around normal for this time of the year so hopefully that'll warm the water...
Yep I got some pricing from the board members. Was just looking to see if there was a dealer in Michigan that could come close, match, or beat the quotes I got to keep the business in state.
Looking to purchase a new MinnKota Ultrex. Anyone here have a MinnKota hook up for good deals?